Abstract:This study aimed to develop an ultraminiature pressure sensor array to measure the force exerted on teeth. Orthodontic force plays an important role in effective, rapid, and safe tooth movement. However, owing to the lack of an adequate tool to measure the orthodontic force in vivo, it remains challenging to determine the best orthodontic loading in clinical and basic research. In this study, a three-dimensional (3D) orthodontic force detection system based on piezoresistive absolute pressure sensors was designed. The 3D force sensing array was constructed using five pressure sensors on a single chip. The size of the sensor array was only 4.1 x 2.6 mm, which can be placed within the bracket base area. Based on the barometric calibration, conversion formulas for the output voltage and pressure of the five channels were constructed. Subsequently, a 3D linear mechanical simulation model of the voltage and stress distribution was established using 312 tests of the applied force in 13 operating modes. Finally, the output voltage was first converted to pressure and then to the resultant force. The 3D force-detection chip was then tested to verify the accuracy of force measurement on the teeth. Based on the test results, the average output force error was only 0.0025 N (0.7169%) (p = 0.958), and the average spatial positioning error was only 0.058 mm (p = 0.872) on the X-axis and 0.050 mm (p = 0.837) on the Y-axis. The simulation results were highly consistent with the actual force applied (intraclass correlation efficient (ICC): 0.997-1.000; p < 0.001). Furthermore, through in vivo measurements and a finite element analysis, the movement trends generated when the measured orthodontic forces that acted on the teeth were simulated. The results revealed that the device can accurately measure the orthodontic force, representing the first clinical test of an orthodontic-force monitoring system. Our study provides a hardware basis for clinical research on efficient, safe, and optimal orthodontic forces, and has considerable potential for application in monitoring the biomechanics of tooth movement.

POSITIONING AND CENTERING SYSTEM AND METHOD FOR TRUE TRIAXIAL HOPKINSON PRESSURE BAR

A Flexible Crosstalk-Free Piezoresistive Pressure Sensor Array Based on Interdigital-Electrode for High-Precision Pressure Mapping

OPTIMAL PLACEMENT OF PIEZOELECTRIC TORSIONAL ACTUATOR/SENSOR BASED ON SMART BAR

Dynamic Behavior of Concrete under Static Triaxial Loading Using 3D-Hopkinson Bar

Radial Displacement Measurement of Hydrogen Storage Cylinders under Internal Pressure Based on Fringe Projection Profilometry

A New Design of Triaxial Test Chamber with Temperature and Pressure for Deep Rock

Rock hopkinson strikes loading experiment device based on true triaxial static load

Dynamic Biaxial Compression Tests Using 4 Symmetric Input Hopkinson Bars

Design and Testing of a Compliant ZTTΘ Positional Adjustment System with Hybrid Amplification

Design and Analysis of a Precision Multi-DOF Placement Device

A NEW TECHNIQUE FOR TESTING SOFT MATERIAL USING A MODIFIED HOPKINSON PRESSURE BAR

A dual-probe three-dimensional profile measurement system

Design and Calibration of a Large-Scale 155-mm Split-Hopkinson Pressure Bar

Large Dimension Hopkinson Pressure Bar and Its Application

A novel Hopkinson tension bar system for testing polymers under intermediate strain rate and large deformation

An electromagnetic Hopkinson bar for low wave impedance material and complex stress paths loading tests

Design, development, and calibration of split Hopkinson pressure bar system for Dynamic material characterization of concrete

Experimental Technique of High Strain-Rate Tension Based on Hopkinson Bar

A Novel Experimental Method of Hopkinson Pressure Bar System for Brittle Material

Fabrication of Three-Dimensional Orthodontic Force Detecting Brackets and Preliminary Clinical Test for Tooth Movement Simulation

Extrinsic calibration method for 3D scanning system with four coplanar laser profilers