Abstract:We propose a novel hybrid FPP-DIC technique to measure an object's shape and deformation in 3D simultaneously by using a single 3CCD color camera, which captures the blue fringe patterns and red fluorescent speckles within the same image. Firstly, red fluorescent speckles were painted on the surface of the specimen. Subsequently, 12 computer-generated blue fringe patterns with a black background were projected onto the surface of the specimen using a DLP projector. Finally, both the reference and deformed images with three different frequencies and four shifted phases were captured using a 3CCD camera. This technique employed a three-chip configuration in which red–green–blue chips were discretely integrated in the 3CCD color camera sensor, rendering independent capture of RGB information possible. Measurement of out-of-plane displacement was carried out through the implementation of Fringe Projection Profilometry (FPP), whereas the in-plane displacement was evaluated using a 2D Digital Image Correlation (DIC) method by leveraging a telecentric-lens-based optical system. In comparison to the traditional FPP-DIC hybrid methodology, the present approach showed a lower incidence of crosstalk between the fringe patterns and speckle patterns while also offering a corrective for the coupling of the in-plane displacement and out-of-plane displacement. Experimental results for the in-plane cantilever beam and out-of-plane disk comparisons with the traditional 3D-DIC method indicated that the maximum discrepancy obtained between FPP-DIC and 3D-DIC was 0.7 μm and 0.034 mm with different magnifications, respectively, validating the effectiveness and precision of the novel proposed FPP-DIC method.

Radial Displacement Measurement of Hydrogen Storage Cylinders under Internal Pressure Based on Fringe Projection Profilometry

Research on Hydrogen Environment Fatigue Test System and Correlative Fatigue Test of Hydrogen Storage Vessel

Non-Destructive Testing Study of Hydrogen Storage COPVs Based on Digital Shearography Technique

Hydrogen Environment Fatigue Test System Development of High Pressure Hydrogen Storage Vessels

Experimental and Numerical Investigation of Radial Displacement of COPV Using CT and FPP Method

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

DESIGN AND OPTIMIZATION OF HIGH-PRESSURE HYDROGEN CYLINDERS FOR INTERMODAL CONTAINER TRANSPORTATION

Study on Burst Pressure of Type Ⅳ Hydrogen Storage Cylinder Based on Progressive Failure Analysis

Study on Dynamic Pressure Effect of Gas Bearings in Fuel Cell Vehicles

Damage Assessment of Liquid Nitrogen Filling on Type III Cylinder in Cryo-Compressed Hydrogen Storage Cylinder

Thermo-mechanical Investigation of Composite High-Pressure Hydrogen Storage Cylinder During Fast Filling

A dual-probe three-dimensional profile measurement system

Measurement of Aluminum Liner Internal Defect Deformation and Strain Using Shearography and FEM Verification

Numerical Simulation on Fast Filling of Hydrogen for Composite Storage Cylinders

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Implementation and Verification of a Dual-Probe Measurement System for Geometric Form Evaluation of a Ring-Type Cylinder

Local Geometric Measurement for 3-D Curved Micro-Pipe

A Measurement Technique On The Hydrodynamic Force On The Free Surface-Piercing Cylinder At A Yawed Angle

Accurate Inner Profile Measurement of a High Aspect Ratio Aspheric Workpiece Using a Two-Probe Measuring System

Internal pressure testing of open-ended filament-wound cylinders using radial expansion of elastomeric inserts

Three-Dimensional Shape and Deformation Measurements Based on Fringe Projection Profilometry and Fluorescent Digital Image Correlation via a 3 Charge Coupled Device Camera