Abstract:Abstract A radiofrequency (RF) ion source with a megawatt power extraction, thunder I, has been developed for the neutral beam injector (NBI) on HL-2A tokamak. A full solid-state RF generator with output power of 80 kW and frequency of 2 MHz was built by an RF combiner using 8 modules of solid-state RF generator with power of P RF = 10 kW. The line electric efficiency of whole RF generator reaches 92% and its voltage standing wave ratio (VSWR) is 1.01, thus no water-cooling system is supplied. A quartz vessel with the inner diameter of 250 mm is directly adopted for resisting atmospheric pressure, which can dramatically simplify source structure. Nowadays, the extracted beam parameters of RF hydrogen ion source are 32 kV/20 A/0.1 s on a test bed, while the design parameters are 50 kV/20 A/3 s. The beam density profile measured by the infrared imaging technique at 1.3 m downstream from the grounded grid obeys a Gaussian distribution, and the corresponding half width of 1/ e power decay at the matched condition is about 80 mm. Plasma homogeneity is over 90% at low RF power. The beam divergence angle meets the requirement of NBI system on HL-2A tokamak. The extractable current density increases almost linearly with the RF power. It reaches 2400 A m −2 at P RF = 32 kW. The ion density in front of plasma grid is about 1 × 10 18 m −3 , corresponding to an ionized fraction of about 1% at the gas pressure of 0.5 Pa. Single hydrogen ion fraction reaches 79% at the beam current of 12.4 A. Some improvements have been considered for optimizing ion source performance on next experimental campaign. One smaller auxiliary RF discharge chamber equipped with a gas feed path, driven by 13.56 MHz/3.5 kW generator, is connected to main discharge chamber driven by 2 MHz/40 kW generator. By this dual-driven configuration, the innovative RF plasma source with high-pressure density gradient solves the initial ignition problem of powerful RF ion source even if the gas pressure below 0.1 Pa. In addition, the RF negative hydrogen ion source of 200 kV/20 A/3600 s is also developed at SWIP for the China fusion engineering test reactor.

The engineering design of quarter size negative beam source for the comprehensive research facility for fusion technology

The engineering design of half-size RF negative ion source for CRAFT-NNBI

Conceptual design of 5 MW-NBI injector for HL-2 M tokamak

Research and development progress of radio frequency ion source for neutral beam injector at ASIPP

The use of the Peltier effect for simple and accurate calibration of thermoelectric devices

Final design and manufacturing of the neutralizer for the negative ion-based neutral beam injector test facility of CRAFT

Copper-free direct C-H trifluoromethylation of acetanilides with sodium trifluoromethanesulfinate.

Design of infrared radiation diagnostic calorimeter for the prototype radio frequency driven negative ion source for neutral beam injection

[Immunological study of the excretions of the sputum of bronchitis patients].

Study on stray electrons ejecting from a long-pulse negative ion source for fusion

Engineering design and manufacturing of a radio frequency plasma driver without Faraday shield for NBI application

Influence of cusp magnetic field configuration on plasma parameters of radio frequency driven negative ion source for CRAFT NNBI

First Prototype of a Cesium Oven Design for Negative-Ion-Source-Based Neutral Beam Injector at ASIPP

Suppression of stray electrons in the negative ion accelerator of CRAFT NNBI test facility

Development of megawatt radiofrequency ion source for the neutral beam injector on HL-2A tokamak

[20 years' experience with Charnley low friction arthroplasty--striving for durability and future prospects].

Design optimization of slit aperture Faraday shield for RF ion source in CRAFT NNBI system

Development of Rf Driver Used in Negative Ion Source at Hust

Design of a compact RFQ linac for the transportable neutron source

Design of acceleration grid power supply for CFETR negative-ion-based neutral beam injection prototype

Simulations for the cesium dynamics of the RF-driven prototype ion source for CRAFT N-NBI