Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Structural Behaviour of T-joints Between High Strength S690 Steel Cold-Formed Circular Hollow Sections

Structural testing and numerical modelling of T-joints between cold-formed S690 circular hollow sections under brace in-plane bending

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Experimental Investigation into High Strength S690 Cold-Formed Circular Hollow Sections under Compression

Experimental study of the static behavior of tubular N-joints

Experimental Study on Edge Cell Partially-Replaced Joint for I-beam to Multi-Celled CFST Walls under Cyclic Loading

EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CFST RECTANGULAR COLUMN TO H-SECTION STEEL BEAM CONNECTIONS WITH EXTERNAL STIFFENERS

Experimental and numerical study on static behaviour of uniplanar CFDST-CHS T-joints

Concrete-Filled Steel and Steel Tubular T-Joints under Cyclic In-Plane Bending

Design of concrete filled tubular CHS T-joints under in-plane bending

Behaviour Of Concrete-Filled Tubular T-Joints Under In-Plane Bending Cyclic Loading

Experimental Study on the Axial Compressive Strength of Vertical Inner Plate Reinforced Square Hollow Section T-joints

Axial Capacity of CHS T-Joints Reinforced with Welded External Stiffeners Under Load

02.05: Design of concrete-filled steel tubular longitudinal gusset plate connections

Experimental Study on Tensile Fracture Mechanism of Butt Joints in Multi-Celled CFST Walls

Investigations into residual stresses in S690 cold formed circular hollow sections due to transverse bending and longitudinal welding

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Scf Distribution Of Concrete-Filled Chs T- And Y- Joints Under Axial Tension

Experimental Investigation and Design of Concrete-Filled Steel Tubular CHS Connections

Cyclic testing on prefabricated joints for steel beam to concrete-filled steel tubular column

Experimental investigation of SCF distribution for thin-walled concrete-filled CHS joints under axial tension loading