Flexible Al-Ti-Zn-O MIM Capacitors Fabricated by Room Temperature Atomic Layer Deposition and Their Electrical Performances

Jin Lei,Chang Fang,Chang Liu,Di Wu,Ai-Dong Li
DOI: https://doi.org/10.1016/j.jallcom.2021.159391
IF: 6.2
2021-01-01
Journal of Alloys and Compounds
Abstract:We pioneered to employ room temperature atomic layer deposition (RTALD) to fabricate flexible Al-Ti-O based metal-insulator-metal (MIM) capacitors on three polymer substrates of polyethylene terephthalate (PET), polyimide (PI) and epoxy resin (epoxy) without any post-processing. Zn was introduced to Al-Ti-O dielectrics to tune its electrical properties through varying ALD cycle ratio and cycle number. Under the optimal processing, the flexible MIM capacitors of Al1.56Ti0.47Zn0.06O3 exhibits comprehensively better performance such as higher capacitance density of 7.4 fF/mu m2, smaller leakage current density of 2 x 10(-8) A/ cm2 at 3 V, and reasonable quadratic voltage linearity of 422 ppm/V2. X-ray photoelectron spectroscopy analyses reveal that the incorporation of a slight amount of Zn into Al-Ti-O dielectrics significantly decreases the oxygen vacancy concentration from 6.7% to 0.8%, beneficial for the improvement of electrical performance. Furthermore, our 2 x 2 cm2 flexible MIM capacitors could bear 4000 bending cycles at bending radius of 8.2 mm, showing better electrical stability. These results indicate that RTALD-derived AlTi-Zn-O dielectrics are competitive MIM capacitor candidates for flexible electronics and wearable devices. RTALD technology exhibits exciting potentials in flexible electronic device fabrication. (c) 2021 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?