Abstract:As power efficiency becomes essential in automotive applications, DC-DC converters are widely employed [1]. However, size and thermal limits have made it challenging to continue using standard CMOS-based converters. Gallium Nitride (GaN) FETs, on the other hand, have a much higher conductivity with small size/capacitance in comparison to silicon FETs, enabling a highly efficient power conversion at high switching frequency (f SW ). However, there are several issues that must be resolved before using GaN in automotive. High f SW incurs larger di/dt and dv/dt transitions which injects high frequency electromagnetic interference (EMI) noise into the input bus. This creates unwanted noise or even a malfunction in a safety-critical system. A bulky input filter can reduce EMI, but it greatly increases size and cost. Several techniques [2-5] are reported to mitigate EMI. Frequency hopping using discrete frequencies is proposed in [2], but cannot spread the frequency evenly to lower the peak noise effectively. Alternatively, a series resistor is typically added at the gate of the GaN FET to slow down the transition [3-4]. However, the switching loss is dramatically increased. To mitigate this, adjustable driving strength is proposed in [5]. Unfortunately, the sensing and driver delays confine its use in low f SW applications, where the switch node rising time is several tens or hundreds of ns. Another issue of high f SW operation is that it causes significant current and voltage spikes due to the parasitics at the drain/source of the high side GaN FET (M H ), which could lead to GaN VDS breakdown or damage on logic-level FETs. Thus, EMI noise suppression and reliable operation of GaN FETs remain as major challenges in realizing high f SW power converters for automotive-use.

Suppressing EMI Noise to CAN Communication by Using Active Gate Driver

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

EMI Emission from Gate Drive Circuit of Boost Converter

Switching Noise Suppression for Hybrid Igbt Modules

An Active Gate Driver Design to Reduce Voltage and Current Overshoots for SiC MOSFET Modules

Turn-on Oscillation Damping for Hybrid IGBT Modules

Crosstalk Analysis and Suppression for a Closed-Loop Active IGBT Gate Driver

Advanced Active Gate Drive for Switching Performance Improvement and Overvoltage Protection of High-Power IGBTs

A Novel Active Gate Driver with Auxiliary Gate Current Control Circuit for Improving Switching Performance of High-Power SiC MOSFET Modules

An Active Gate Driver for Suppressing the Current Oscillation of SiC MOSFET

A Novel Active Gate Driver for Improving SiC MOSFET Switching Trajectory

Effect of Common-Mode Interference on Communication Performance of a Motor Drive System

A novel active gate drive for HV-IGBTs using feed-forward gate charge control strategy

Active Gate Driver for Dynamic Current Balancing of Parallel-Connected SiC MOSFETs

An Active Gate Driver for Dynamic Current Sharing of Paralleled SiC MOSFETs

The Active Gate Driver Based on Hardware ClosedLoop Control for Crosstalk Suppression of SiC MOSFETs with Kelvin-Source Connection

Analysis for Crosstalk of SiC-MOSFET in a Bridge Circuit and Its Active-Clamped Driver Based Suppression Methods

An Active Gate Driver for Improving Switching Performance of SiC MOSFET

On the Damping of Ringing Affecting Power Transistors by Means of Active Gate Drivers

Resonant Gate Drive Circuit with Active Clamping to Increase Efficiency and Reliability