Abstract:As power efficiency becomes essential in automotive applications, DC-DC converters are widely employed [1]. However, size and thermal limits have made it challenging to continue using standard CMOS-based converters. Gallium Nitride (GaN) FETs, on the other hand, have a much higher conductivity with small size/capacitance in comparison to silicon FETs, enabling a highly efficient power conversion at high switching frequency (f SW ). However, there are several issues that must be resolved before using GaN in automotive. High f SW incurs larger di/dt and dv/dt transitions which injects high frequency electromagnetic interference (EMI) noise into the input bus. This creates unwanted noise or even a malfunction in a safety-critical system. A bulky input filter can reduce EMI, but it greatly increases size and cost. Several techniques [2-5] are reported to mitigate EMI. Frequency hopping using discrete frequencies is proposed in [2], but cannot spread the frequency evenly to lower the peak noise effectively. Alternatively, a series resistor is typically added at the gate of the GaN FET to slow down the transition [3-4]. However, the switching loss is dramatically increased. To mitigate this, adjustable driving strength is proposed in [5]. Unfortunately, the sensing and driver delays confine its use in low f SW applications, where the switch node rising time is several tens or hundreds of ns. Another issue of high f SW operation is that it causes significant current and voltage spikes due to the parasitics at the drain/source of the high side GaN FET (M H ), which could lead to GaN VDS breakdown or damage on logic-level FETs. Thus, EMI noise suppression and reliable operation of GaN FETs remain as major challenges in realizing high f SW power converters for automotive-use.

EMI Emission from Gate Drive Circuit of Boost Converter

A Tri-Slope Gate Driving GaN DC–DC Converter with Spurious Noise Compression and Ringing Suppression for Automotive Applications

25.2 A 10mhz 3-to-40v VIN Tri-Slope Gate Driving GaN DC-DC Converter with 40.5dbµv Spurious Noise Compression and 79.3% Ringing Suppression for Automotive Applications

A New Hybrid Gate Drive Scheme for High Frequency Buck Voltage Regulators

A 95.3% Peak Efficiency 38mV overshoot and 5mV/A load regulation Hysteretic Boost Converter with Anti-Phase Emulate Current Control

Suppressing EMI Noise to CAN Communication by Using Active Gate Driver

Turn-on Oscillation Damping for Hybrid IGBT Modules

EMI mitigation in switching power converters combining closed‐loop gate drive and chaotic frequency modulation technique

Study on Radiated Emission Factors and Their Effects in a Boost Switched Mode Power Supply

An Active Gate Driver Design to Reduce Voltage and Current Overshoots for SiC MOSFET Modules

Switching Noise Suppression for Hybrid Igbt Modules

A Novel Multi-stage IGBT Driving Method

Analysis for Crosstalk of SiC-MOSFET in a Bridge Circuit and Its Active-Clamped Driver Based Suppression Methods

Resonant Gate Drive Circuit with Active Clamping to Increase Efficiency and Reliability

Open-Loop Gate Control for Optimizing the Turn-ON Transition of SiC MOSFETs

A Technique on Driving-pulse Edge-modulation and Its Application in Reducing the Switching Voltage Spike of Power Electronic Device

A Hybrid Active Gate Drive for Switching Loss Reduction and Voltage Balancing of Series-Connected IGBTs

High-frequency Driving Circuit and Loss Analysis of SIC MOSFET Based on Discrete Components

A Load Adaptive Intelligent IGBT Gate Drive

Conducted EMI reduction in IGBT-based converters

Magnetic Coupling Common Mode Conducted EMI Analysis and Improvement in a Boost Converter