Abstract:In this paper, the effect of micro-dimple textures (produced by a laser) on the tribological properties of bearings is investigated. This study offers guidelines to reduce the friction torque of the bearing pair and addresses the problem of difficult start-ups after shutdowns. Micro-pits with different texture diameters and depths were machined on the surface of journal bearings. Then, the impact of several different texture parameters on the tribological performance of the bearing pairs was studied using an orthogonal experimental design. Subsequently, the surface morphology of the bearings before and after the friction and wear test was observed using scanning electron microscopy (SEM) and energy-dispersive spectrometry (EDS). These observations were then used to determine the type/state of friction and wear, which also improves our understanding of how texture affects the service life of bearings. The results indicate that the bearings’ micro-pit surface hardness follows an approximate parabolic spatial distribution that decreases along the micro-pit wall. Furthermore, the laser processing of surface textures was found to cause hardening in certain areas, and the chemical composition of elemental carbon and oxygen at the inner surface of processed bearings increased by 31.1% and 7.9%, respectively. Moreover, abrasive wear was identified as the primary form of wear. The textured surface’s antifriction mechanism primarily functioned to trap particles, which acted as a secondary lubrication source and altered the lubrication states by serving as a medium for supplied lubricants. The results confirm that a suitable selection of texture parameters can not only effectively reduce the friction coefficient without shortening the service life of the bearing pair but also facilitate the smooth start-up of the rotor–bearing system.

An Optimization Research on Groove Textures of a Journal Bearing Using Particle Swarm Optimization Algorithm

The optimization design for the journal-thrust couple bearing surface texture based on particle swarm algorithm

Optimization of Groove Texture Profile to Improve Hydrodynamic Lubrication Performance: Theory and Experiments

Adaptive Multi-Objective Optimum Design of Journal Bearing Based on A Back-Stepping Approach

Experimental investigation for vibration reduction of surface-textured journal bearings

A Design of Coverage Area for Textured Surface of Sliding Journal Bearing Based on Genetic Algorithm

An Optimization Research on the Coverage of Micro-Textures Arranged on Bearing Sliders

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Investigation and optimization of textured thrust bearings with spirally distributed dimples using multi-objective optimization method

Optimization of twin grooved two-lobe textured hydrodynamic journal bearing design by using genetic algorithm

Optimization Numerically for Five-Pad Tilting-Pad Journal Bearings Design Based on Particle Swarm

Optimization of Boundary Slip Region on Bearing Sliders to Improve Tribological Performance

Optimal design of surface texture in meso scale air journal bearing

Improvement of Tribological Behaviors by Optimizing Concave Texture Shape Under Reciprocating Sliding Motion

Numerical analysis of lubrication properties on a bio-inspired parabolic textured surface

Analysis on the lubrication performance of spiral-grooved journal bearing using CFD technique

Coupled Optimization of Groove Texture for Parallel Ring–Ring Friction Pairs: Theory and Experiments

Effects of Double Parabolic Profiles with Groove Textures on the Hydrodynamic Lubrication Performance of Journal Bearing under Steady Operating Conditions

A Study on Micro-Pit Texture Parameter Optimization and Its Tribological Properties

Optimal Design of Surface Texture in Parallel Thrust Bearings

The influences of lubricant groove shape on the tribological properties of journal bearing under the grease lubrication conditions