Abstract:In this paper, the effect of micro-dimple textures (produced by a laser) on the tribological properties of bearings is investigated. This study offers guidelines to reduce the friction torque of the bearing pair and addresses the problem of difficult start-ups after shutdowns. Micro-pits with different texture diameters and depths were machined on the surface of journal bearings. Then, the impact of several different texture parameters on the tribological performance of the bearing pairs was studied using an orthogonal experimental design. Subsequently, the surface morphology of the bearings before and after the friction and wear test was observed using scanning electron microscopy (SEM) and energy-dispersive spectrometry (EDS). These observations were then used to determine the type/state of friction and wear, which also improves our understanding of how texture affects the service life of bearings. The results indicate that the bearings’ micro-pit surface hardness follows an approximate parabolic spatial distribution that decreases along the micro-pit wall. Furthermore, the laser processing of surface textures was found to cause hardening in certain areas, and the chemical composition of elemental carbon and oxygen at the inner surface of processed bearings increased by 31.1% and 7.9%, respectively. Moreover, abrasive wear was identified as the primary form of wear. The textured surface’s antifriction mechanism primarily functioned to trap particles, which acted as a secondary lubrication source and altered the lubrication states by serving as a medium for supplied lubricants. The results confirm that a suitable selection of texture parameters can not only effectively reduce the friction coefficient without shortening the service life of the bearing pair but also facilitate the smooth start-up of the rotor–bearing system.

Investigation and optimization of textured thrust bearings with spirally distributed dimples using multi-objective optimization method

Optimization of surface texture distribution on the thrust bearing using the mass-conserving cavitation boundary condition: Theory and experiments

Research on tribological performance of textured thrust bearing using gray relational degree and improved multi-objective water circulation algorithm

Effects of Differently Shaped Textures on the Tribological Properties of Static and Dynamic Pressure Thrust Bearings and Multiobjective Optimization

Texture Optimization and Verification for the Thrust Bearing Used in Rotary Compressors Based on a Transient Tribo-Dynamics Model

Evaluation and Optimization of Axial Piston Pump Textured Slipper Bearings with Spherical Dimples Based on Hybrid Genetic Algorithm

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Multi-objective Optimization of Surface Texture for the Slipper/swash Plate Interface in EHA Pumps

Optimal Design of Surface Texture in Parallel Thrust Bearings

Effect of surface square textures on the physical field of static and dynamic pressure thrust bearings and multi-objective optimization

Multi-objective Optimization of Micron-Scale Surface Textures for the Cylinder/valve Plate Interface in Axial Piston Pumps

A Distribution Design for Circular Concave Textures on Sectorial Thrust Bearing Pads

Investigations for vibration and friction torque behaviors of thrust ball bearing with self-driven textured guiding surface

A Study on Micro-Pit Texture Parameter Optimization and Its Tribological Properties

Study on Static Characteristics of Water-Lubricated Textured Spiral Groove Thrust Bearing Using Laminar Cavitating Flow Lubrication Model

Research on Internal Flow Field Characteristics of Straight-Groove Texture Using Three-Dimensional Modeling

Optimization Tool Based on Multi-Objective Adaptive Surrogate Modeling for Surface Texture Design of Slipper Bearing in Axial Piston Pump

The optimization design for the journal-thrust couple bearing surface texture based on particle swarm algorithm

Parametric Design of Surface Textures on Journal Bearing

An Optimization Research on Groove Textures of a Journal Bearing Using Particle Swarm Optimization Algorithm

Numerical Simulation and Experimental Investigation on Tribological Performance of Micro-Dimples Textured Surface under Hydrodynamic Lubrication