Effect of Non-Uniform Airflow on the Performance of a Parallel-Flow Heat Exchanger Considering Internal Fluid Distribution—simulation Studies and Its Experimental Validation

Lanping Zhao,Bei Wang,Jianxin Wang,Zhijun Zhu,Tiantian Li,Bentao Guo,Jun Zhang,Hao Zhang,Zhigang Yang
DOI: https://doi.org/10.1016/j.applthermaleng.2020.115685
IF: 6.4
2020-01-01
Applied Thermal Engineering
Abstract:A series of tests under uniform and non-uniform airflow conditions were conducted to study the influence of airflow form on the heat transfer capacity of a parallel-flow heat exchanger (PFHX) used as a vehicle radiator. A numerical model of the heat exchanger (HX) based on the principle of internal pressure balance (PIPB) and the method of effectiveness-NTU was proposed, which included the coupled relation between internal fluid distribution and outside airflow distribution. A movable multi-propeller-based device was used to measure the air velocity distribution of the HX in bench test as well as in vehicle wind tunnel test to validate the numerical model. Besides the mean air velocity and the non-uniformity of airflow distribution, the matching degree of the fluid distributions of the two sides (M) was first taken into consideration to investigate the thermal performance of the HX in uneven airflow. It was found that, under the same mean air velocity and non-uniformity, better matching degree of the two side fluid distribution resulted in smaller performance deterioration. Airflow with low mass flow rate and better matching degree of flow distributions could even improve the heat exchanger performance, especially for the HX with small aspect ratios. The results of vehicle wind tunnel test further proved the effectiveness of the method in this work to predict the performance of the HX under realistic uneven airflow.
What problem does this paper attempt to address?