Abstract:Multi-channel wire electrical discharge machining (WEDM) is widely used for slicing semiconductor materials and improving cutting rate through multi-channel discharge. However, enhancing the cutting rate of integral metal workpieces through the utilization of multi-channel WEDM remains a challenge. This paper investigated the discharge characteristics of metal workpiece using multi-channel high-speed WEDM (HSWEDM). It was discovered that due to the high conductivity of the metal workpiece, there is electrical signal coupling between each channel, which inhibits the independent discharge of each channel and severely impacts the improvement of cutting rate. To solve this problem, a new power supply with a decoupled circuit was designed, and the potential difference between adjacent channels was formed by using a current-limited resistor at each output, reducing coupling between the channels and enabling independent discharges at each channel, thereby improving the cutting rate of metal materials. The effect of current-limited resistance ( R c ) on multi-channel synchronous discharges was analyzed through online acquisition of discharge signals, demonstrating that reducing the R c can improve the discharge ratio. In the two-channel HSWEDM with the new power supply, when the R c is reduced from 15 to 5/3 Ω, the gap voltage is increased from 31 to 64 V, the discharge ratio is increased from 0.967 to 1.566, and the increase in cutting rate was from 19.06% to 83.02%. Furthermore, when R c is 5/2 Ω, the cutting rate was 1.660–1.971 times that of conventional power supply. Since each channel can implement independent servo control after electrical signal decoupling, the dimensional uniformity and surface topography of grooves are improved, and the thickness of the recast layer is reduced. Lastly, the new power supply was applied to the four-channel HSWEDM, resulting in a significant increase in cutting rate, which was 3.538 times higher than that of conventional power supply.

A Discharge Pulse Discrimination Strategy for High Speed WEDM with Power-Electronic-based Pulse Power Generator

A Denoise Method of Electrical Discharge Machining Gaps Signal for Non-Conductive Engineering Ceramics Based on Wavelet Mma

High Resolution Digital Pulse Width Modulation Design For Digital Dc-Dc Converter

Monitoring Of Edm Gap Discharge Status With Wavelet Transform Method

Experimental Research on Pulse Generator for EDM of Non-Conductive Ceramics

Gap status identification and control of wire electrochemical micromachining

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode

Study on discharge characteristics and process of multi-channel high-speed wire electrical discharge machining for metal workpieces

Study of Alternating Current Flow in Micro-Edm Through Real-Time Pulse Counting

Study on characteristics of EDM using pulse power supply with active high-frequency oscillation

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Research on a two-stage discharge current regulation method in RT-WEDM

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process

Research of Multimode Pulse Power Supply for Micro-EDM

Implementation of a No Pulse Competition CPS-SPWM Technique Based on the Concentrated Control for Cascaded Multilevel DSTATCOMs

Enhancing Cutting Rates in Multi-Channel HSWEDM of Metal Materials with a Novel Decoupling Circuit

Determination of the Optimal Servo Feed Speed by Thermal Model During Multi-Pulse Discharge Process of WEDM

An EDM pulse power generator and its feasible experiments for drilling film cooling holes

A discharge plasma regulation method with spike current for electrical discharge machining

Spark Analysis Based on the CNN-GRU Model for WEDM Process

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.