Abstract:Purpose: Computational fluid dynamics (CFD) and 4D-flow magnetic resonance imaging (MRI) are synergically used for the simulation and the analysis of the flow in a patient-specific geometry of a healthy thoracic aorta. Methods: CFD simulations are carried out through the open-source code SimVascular. The MRI data are used, first, to provide patient-specific boundary conditions. In particular, the experimentally acquired flow rate waveform is imposed at the inlet, while at the outlets the RCR parameters of the Windkessel model are tuned in order to match the experimentally measured fractions of flow rate exiting each domain outlet during an entire cardiac cycle. Then, the MRI data are used to validate the results of the hemodynamic simulations. As expected, with a rigid-wall model the computed flow rate waveforms at the outlets do not show the time lag respect to the inlet waveform conversely found in MRI data. We therefore evaluate the effect of wall compliance by using a linear elastic model with homogeneous and isotropic properties and changing the value of the Young's modulus. A stochastic analysis based on the polynomial chaos approach is adopted, which allows continuous response surfaces to be obtained in the parameter space starting from a few deterministic simulations. Results: The flow rate waveform can be accurately reproduced by the compliant simulations in the ascending aorta; on the other hand, in the aortic arch and in the descending aorta, the experimental time delay can be matched with low values of the Young's modulus, close to the average value estimated from experiments. However, by decreasing the Young's modulus the underestimation of the peak flow rate becomes more significant. As for the velocity maps, we found a generally good qualitative agreement of simulations with MRI data. The main difference is that the simulations overestimate the extent of reverse flow regions or predict reverse flow when it is absent in the experimental data. Finally, a significant sensitivity to wall compliance of instantaneous shear stresses during large part of the cardiac cycle period is observed; the variability of the time-averaged wall shear stresses remains however very low. Conclusions: In summary, a successful integration of hemodynamic simulations and of MRI data for a patient-specific simulation has been shown. The wall compliance seems to have a significant impact on the numerical predictions; a larger wall elasticity generally improves the agreement with experimental data.

Simulation of Water Diffusion Through a Simple Virtual Cardiac Cell Model: Optimization of Monte Carlo Parameters and Observation by Simulated MRI

Simulation Study of A Magnetocardiogram Based on A Virtual Heart Model: Effect of A Cardiac Equivalent Source and A Volume Conductor

Monte Carlo Simulation of Water Diffusion Through Cardiac Tissue Models.

Simulation of MCG Signal in 2D Cardiac Tissue Sheet with Ischemic Condition

Effect of Cardiac Motion on Body Surface Electrocardiographic Potentials: an Mri-Based Simulation Study

Intra-ventricular Blood Flow Simulation with Patient Specific Geometry

A generative model of realistic brain cells with application to numerical simulation of diffusion-weighted MR signal

Accurate numerical simulation of electrodiffusion and water movement in brain tissue

One-dimensional Simulation of Transmural Heterogeneity of Cardiac Cellular Electromechanics

Integration of Different Cardiac Electrophysiological Models into a Single Simulation Pipeline

Realistic Microstructure Simulator (RMS): Monte Carlo simulations of diffusion in three-dimensional cell segmentations of microscopy images

Simulation Of Diffusion Anisotropy In Dti For Virtual Cardiac Fiber Structure

Realistic voxel sizes and reduced signal variation in Monte-Carlo simulation for diffusion MR data synthesis

Three-dimensional micro-structurally informed in silico myocardium -- towards virtual imaging trials in cardiac diffusion weighted MRI

Quantitative perfusion and water transport time model from multi b-value diffusion magnetic resonance imaging validated against neutron capture microspheres

Connecting macroscopic diffusion metrics of cardiac diffusion tensor imaging and microscopic myocardial structures based on simulation

Blood Flow Simulation, Patient-Specificin-vivo

Verification Study of in Silico Computed Intracardiac Blood Flow With 4D Flow MRI

Validation of Numerical Simulations of Thoracic Aorta Hemodynamics: Comparison with In Vivo Measurements and Stochastic Sensitivity Analysis

Numerical simulation of blood flow in the left ventricle and aortic sinus using magnetic resonance imaging and computational fluid dynamics

Model discovery approach enables noninvasive measurement of intra-tumoral fluid transport in dynamic MRI