Abstract:In off-axis subapertures of most convex aspheres, astigmatism and coma dominate the aberrations with approximately quadratic and linear increase as the off-axis distance increases. A pair of counter-rotating computer generated hologram (CGH) plates is proposed to generate variable amount of Zernike terms Z4 and Z6, correcting most of the astigmatism and coma for subapertures located at different positions on surfaces of various aspheric shapes. The residual subaperture aberrations are then reduced within the vertical range of measurement of the interferometer, which enables near-null test of aspheres flexibly. The alignment tolerances for the near-null optics are given with optomechanical analysis. Accordingly a novel design for mounting and aligning the CGH plates is proposed which employs three concentric rigid rings. The CGH plate is mounted in the inner ring which is supported by two couples of ball-end screws in connection with the middle ring. The CGH plate along with the inner ring is hence able to be translated in X-axis and tipped by adjusting the screws. Similarly the middle ring is able to be translated in Y-axis and tilted by another two couples of screws orthogonally arranged and connected to the outer ring. This design is featured by the large center-through hole, compact size and capability of four degrees-of-freedom alignment (lateral shift and tip-tilt). It reduces the height measured in the direction of optical axis as much as possible, which is particularly advantageous for near-null test of convex aspheres. The CGH mounts are then mounted on a pair of center-through tables realizing counter-rotation. Alignment of the interferometer, the CGHs, the tables and the test surface is also discussed with a reasonable layout of the whole test system. The interferometer and the near-null optics are translated by a three-axis stage while the test mirror is rotated and tilted by two rotary tables. Experimental results are finally given to show the near-null subaperture test capability of the system for a convex even asphere.

The Research of Using CGH to Test Aspherical Lens

Study on testing larger asphericity in non-null interferometer - art. no. 68340T

Research on Two Optical Methods for Aspheric Measurement

Measurement of Convex Aspheric Lens' Optical Performance Using Computer-Generated Holograms

Measurement of Aspheric Surface

Research of precision interference locating method for a partial null compensator at aspheric testing

Analysis for Property of CGH on Spherical Surface Used for Aspheric Surface Testing

Non-null interferometric aspheric testing with partial null lens and reverse optimization

Design and Error Analysis of the CGH Used for Aspheric Test

Using Computer-Generated Holograms to Test Cubic Surface

Null Test of Aspheric Surface Based on Digital Phase-Shift Interferometer

Use of Virtual Medium in Designing of the CGH Wave Front Generator for Aspheric Testing

Problems on Design of Computer-Generated Holograms for Testing Aspheric Surfaces: Principle and Calculation

Simulation Of Aspheric Tolerance With Polynomial Fitting

Asphericity and Discrete Phase Calculation for Optical Freeform Surface Test with Computer Generated Holograms

A Novel Method of Measuring Convex Aspheric Lens Using Hologram Optical Elements

New Design Techniques and Alignment Methods for Cgh-Null Testing of Aspheric Surface

Optomechanical Design of Near-Null Subaperture Test System Based on Counter-Rotating CGH Plates

Problems on Fabrication of Computer-Generated Holograms for Testing Aspheric Surfaces

Design of CGH for Testing Large Off-Axis Asphere by Considering Mapping Distortion

Characterization of the contribution of CGH fabrication error to measurement uncertainty in null test