Simulation of welding deformation of complex structures in high-speed trains

Lichun MENG,Jijin XU,Yuanying FAN,Xiaohong SUN

DOI: https://doi.org/10.3969/j.issn.1673-4807.2017.03.008

2017-01-01

Abstract:In order to simulate the welding process of complex welded structure in high-speed trains,a quick welding simulation method is proposed based on an average temperature curve method.A multi pass welding experiment of A7N01 aluminum alloy plate was carried out.The welding process was simulated by a moving heat source method and the average temperature curve method,respectively.Through the comparison of the welding deformations and the residual stresses simulated by the two calculation methods with those measured,we conclude that the average temperature method was validated to replace the moving heat source method in simulating the welding process.The results show that the simulated welding residual stresses and deformation by average temperature method are in good agreement with the results by the moving heat source method,which are consistent with the measured values.Therefore,the average temperature method can replace the moving heat source method in simulating the welding process of complex welded structure.The welding process of sleeper beam was simulated based on the average temperature method.The predicted welding deformations of the sleeper beam show the same change trend with the measured results.The error between the calculated values and the measured values is less than 10%.