Abstract:High voltage (HV) converter transformer is one of the most important power equipment in DC transmission system. The determination of transient voltage distribution along the winding plays an important role in the insulation design of converter transformer. In this paper an equivalent circuit model for the single-phase converter transformer with the double wound windings has been established, which is mainly composed of longitudinal capacitance, longitudinal inductance and radial capacitance. Both finite element and analytical methods were applied in the calculation of winding capacitance parameters. A combined twelve-pulse rectifier equivalent circuit model, consisted of six single-phase converter transformer and twelve converter valves, was established by means of the PSCAD/EMTDC software. The maximum transient voltage on the terminals of six converter transformers caused by a lightening stroke to the DC transmission line was analyzed. And therefore, the transient voltage characteristics along six converter transformer windings, such as maximum potential distribution and the gradient voltage of each winding disk, were obtained, respectively. The calculated results show that voltage and gradient voltage corresponding to the conducting phase and the non-conducting phase transformers have the same variation trend. The maximum voltage occurs at the end of the winding next to the neutral point of the transformer, while the maximum gradient voltage locates at the head of the winding.

Study on Harmonic Current of Air Welding Transformer

Calculation Method of Winding Eddy-Current Losses for High-Voltage Direct Current Converter Transformers

Simulation and Analysis of Electromagnetic Properties at the Secondary Port of Electronic Current Transformers Under Very Fast Transient Overvoltage

Modeling and simulating of unloading welding transformer

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

A Continuously Magnetic Valve Arc-Suppression Coil and Its Modeling

Analysis of Harmonic Current and Winding Vibration in Converter Transformer

Study on Modeling and Simulation of Short Circuit Transfer of Inverter Arc Welding System

Research and Evaluation of the Transformer Harmonic Model

Study on the Harmonic Losses of UHV Converter Transformer Windings Subject to Non-sinusoidal Load Current

Simulations on Harmonic Analysis of Arc Furnace Electrical System

Magnetic Field Analysis of HTS Transformer Windings with High Currents

Modeling of Eddy-Current Losses of Welded Laminated Electrical Steels.

Study on Finite Element Method Applied in Winding Deformation Monitoring for Calculating the Leakage Inductance of Power Transformer

Features and Mechanism of Negative-sequence Second Harmonics of Magnetizing Inrush Current in Transformers

On-line Method for High-sensitivity Leakage Current Measurement of Converter-connected Transformers in Microgrids

Numerical Analysis Of Lightning Transient Voltage Distributions In Hv Converter Transformer Winding

Three-Dimensional Simulation of the Magnetic Field and Leakage Magnetic Field in Switching Mode Power Supply Transformer

Study on the Influence of HVDC System Grounding Electrode Current on Power Transformer Operation

Numerically Investigating Interturn Arcing Faults Inside a UHV Converter Transformer

Harmonic model of power transformer