Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Simulation of the Safety Against Ac and Dc Current Shock Pulses in a High Temperature Superconductive Coil

Apparatus and Experiment of High Temperature Superconducting Magnetic Energy Storage Used for Power System Stability Enhancement

Development of a Conduction-Cooled HTS SMES

Performance of an HTS Generator Field Coil under System Fault Conditions

Fast evaluation of the critical current of high-temperature superconducting coils based on the integral method

The stability of the high temperature superconducting DC coils with defects

A Pulsed Current Charging Mechanism for High Temperature Superconducting Magnets

Two Quenched Models for High-Temperature Superconducting Insulated Coils

Over-Current Simulation Test for High Temperature Superconducting Generator

Shock dynamics model based on the conductor hardening and thermal softening effects for single-turn coil

The Interaction Between a High-Temperature Superconducting Coil and In-Series Permanent Magnets

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Simulation of Stacks of High Temperature Superconducting Coated Conductors Magnetized by Pulsed Field Magnetization Using Controlled Magnetic Density Distribution Coils

AC Analysis of a High Temperature Superconductor Coil with Short Circuits

Effect of local and global screening current on the current decay in closed-loop HTS coils

Holistic numerical simulation of a quenching process on a real-size multifilamentary superconducting coil

Test and Analysis of Electromagnetic and Mechanical Properties of HTS Coil During Quench State

Multiscale modelling on the multi-physical behaviors of high temperature superconducting magnets based on a combined global homogenization and local refinement scheme

A Real-time Monitoring System for Investigating Electromagnetic Behaviors of An HTS Coil

Simulation of High Temperature Superconducting Bulks Magnetized by Pulsed Field Magnetization with an Electromagnetic-Thermal Coupled Model

Numerical Study on Thermal Stability of No-Insulation Coils Using a Three-Dimensional Finite-Element Model