Abstract:Alumina as dielectric material is commonly prepared via anodizing high purity etched foils in electrolyte, which vitally determines the performance of aluminum electrolytic capacitor. However, the traditional direct-current (DC) anodizing is limited due to a large amount of Joule heat production, a space charge layer, and unnecessary side reactions, which result in great energy consumption and a poor quality of oxide film. In this work, the symmetric pulsed-current (SPC) anodizing is introduced into the anodization of aluminum foil for electrolytic capacitor. SPC anodizing can contribute to the diffusion of heat during the non-anodization period because of its pulse mode, lowering the thermally induced dissolution of alumina reacted with water. In addition, SPC anodizing can suppress the formation of a space charge layer by alternating the electric field so as to extract impurities out of the oxide film and lower the energy consumption. Moreover, the SPC samples own the denser barrier-type alumina, which have better crystallinity resulting in higher permittivity. Voltage-current output and side reactions during the anodizing process have been analyzed, demonstrating the lower energy consumption and higher production efficiency of the SPC method. In comparison with the DC anodized samples, the specific capacitances of SPC samples are elevated by 10.84% and the energy consumption of the SPC method is decreased by 25.5% in total. Therefore, the SPC anodizing method has a good prospect for industrialization of aluminum electrolytic capacitor.

Research of Inhibitor for Aluminum Foil during DC-etching

Comparative Research on Etched Aluminum Foils Fabricated by Different Techniques for Aluminum Electrolytic Capacitor

Study on technology and mechanism of DC impulse current etching of aluminum foil for middle and high voltage electrolytic capacitor

Influences of trace metal ions in electrolyte on the etching characteristics of high purity aluminum foil under DC current

Study on Aluminum Foils for Aluminum Electrolytic Capacitor

Improvement upon anode oxide film on etched aluminum foil for electrolytic capacitor

Growth Control of Transverse Tunnels for Al Foil in Electrolytic Capacitor

Progress in the Studies of Anode Foils for High Voltage Electrolytic Capacitor

Effect of frequency and current density on A.C. etching of aluminum electrolytic capacitor foil

Symmetric Pulsed Anodizing of Aluminum Foil for Aluminum Electrolytic Capacitors

Study on Mechanism of Electrochemical Corrosion of Al-foil for Aluminum Electrolytic Capacitor Anode

Effect of Cerium Addition on Microstructure and Texture of Aluminum Foil for Electrolytic Capacitors

Research on new hydration-resistant reagent for anodic foil of aluminum electrolytic capacitor

Research on the Anodic Aluminum Oxide As Anodic Foil of Aluminum Electrolytic Capacitor

On the etching mechanism of surface area enlarging of aluminum foils used as high-voltage electrolytic capacitors anodes

Effect of azelaic acid on microstructure evolution and electrical properties of anodic aluminum foil for electrolytic capacitor

Effect of Pretreatment on the Pitting Corrosion of the Anode Foils for the Aluminum Electrolytic Capacitor

Effect of Annealing Technology on Oxide Film and Specific Capacity of Aluminum Foils for Low Voltage Electrolytic Capacitors

Effect of Annealing Method on Microelements Distribution and Corrosion Performance of Aluminum Foil for Low Voltage Electrolytic Capacitor

Effect of adding trace metal ions and metal oxide on corrosion property of anode aluminum foil and mechanism analysis

Effect of Etch Conditions on Expanding Surface Corrosion of Anodic Foil for Aluminum Electrolytic Capacitors