Abstract:A novel tunnel growth model is proposed to reveal how hydrogen is transported out of tunnels and explain the phenomena during etching process of aluminum foil for capacitor. Experimental results indicated that tunnel density increased and tunnel width decreased with temperature increasing at the temperature range of 70–80°C. The pressure in electrolyte had an effect on the tunnel density. The tunnel density after etching at 0.2atm was larger than that at 1atm. A pulse electrochemical etching process is described according to the novel tunnel growth model. It considers that hydrogen bubble of nanometer dimension is absorbed on the tunnel’s walls surface during the pulse electrochemical etching process, and the saturated hydrogen at the end of the tunnel is accumulated to be a large bubble before hydrogen is transported out of the tunnel. The large bubble will emanate from the end of tunnel when the pressure in the bubble is equal to that outside. The wall surface passivation phenomena is explained by this model; the naturally corrugated texture with ripples of about 0.1μm in tunnel’s walls surface is regarded to be produced by the potential periodical changes, which are caused by the large hydrogen bubble at the end of the tunnel. At the same time, the effect of temperature and pressure on the morphology of the tunnel is also investigated by use of the model. The pressure of the large hydrogen bubble in the tunnel is calculated according to the date in other references when the period of the pulse electrochemical etching is inferred to be 3ms at their experimental conditions. The proposed process of pulse electrochemical etching could explain well the calculation results and the SEM images of etched tunnels under the same experimental conditions.

Growth Control of Transverse Tunnels for Al Foil in Electrolytic Capacitor

Research Progress of Tunnel Growth in Aluminum Foil for Capacitor

Second Growth Law of Tunnel Hole in Etched Aluminum Foil for Electrolytic Capacitor

Tunnel Morphology of Aluminum Foil Etched by a Two-Step DC Etching Method

Tunnel Growth Mechanism of Aluminum Foils During Etching on Corrosion Cell

Effect of Etch Conditions on Expanding Surface Corrosion of Anodic Foil for Aluminum Electrolytic Capacitors

Research of Tunnel Growth in Aluminum Foil for Capacitor

The Influence of H2SO4/HCl Ratio and Al3+ Content on the Tunnel Growth of High Purity Aluminum Foil

Electrochemical etching model in aluminum foil for capacitor

Effects of the solution flow rate on the growth of aluminum etch tunnels

Study on technology and mechanism of DC impulse current etching of aluminum foil for middle and high voltage electrolytic capacitor

Effects of Current Density on the Growth of Aluminum Etch Tunnels

Comparative Research on Etched Aluminum Foils Fabricated by Different Techniques for Aluminum Electrolytic Capacitor

Formation and Mechanistic Analysis of Self-Etched Tunnels on the Surface of Aluminum Foil by the Electrodeposition of Trace Cu to Form an Electrolytic Capacitor

On the etching mechanism of surface area enlarging of aluminum foils used as high-voltage electrolytic capacitors anodes

Effect of Bipolar Electrochemical Process on Tunnel Etching Characteristics of Aluminum Foil

Research of Inhibitor for Aluminum Foil during DC-etching

Surface Modification of Al Foils for Aluminum Electrolytic Capacitor

Effect of Pretreatment on the Pitting Corrosion of the Anode Foils for the Aluminum Electrolytic Capacitor

Effect of frequency and current density on A.C. etching of aluminum electrolytic capacitor foil

Effect of azelaic acid on microstructure evolution and electrical properties of anodic aluminum foil for electrolytic capacitor