Abstract:Loading measurement is one of the critical components of mechanical tests. Different technologies are applied for loading measurement at different spans of time and space. In the past century, the quasi-static hypothesis has been widely applied for low-speed loading conditions (strain rate < 1/s), and the stress wave theory has been applied for high-speed loading conditions (strain rate > 1000/s). However, so far, the feasibility of the quasi-static and stress wave approaches for loading measurement is questionable under intermediate strain rate loading conditions (1 000/s > strain rate > 1/s).For quasi-static approach, the signal ringing (caused by dynamic oscillation) is the main problem that hinders the accuracy of the loading measurement with the increment of strain rate. In this present study, in order to tackle the ringing signal obtained from the intermediate strain rate material test, a signal recognition algorithm was introduced, named the semi-period perturbation algorithm (SPPA). As SPPA is based on the first-order spring-mass oscillatory model, the corresponding test method for intermediate strain rate test was called single-mode method (SMM). To satisfy the basic hypothesis of SPPA, the corresponding load cell and material specimen was designed. Through modal analysis and dynamic simulations, SPPA and the load cell-specimen assembly were proved effective in restoring the loading signal from the ringing signal. Based on the high-speed tests of 6061 aluminum alloy and Q235 steel, and compared with the preponderant material test approach based on SEP 1230/ISO 26,203-2 sample, the SMM was proved effective in the loading measurement of intermediate strain rate tests. What's more, based on the accessibility of the test design and the simplicity of the data processing procedure of SMM, this method exhibited great application potential for similar mechanical scenarios of impact tests.

Development of Material Testing Apparatus for Intermediate Strain Rate Test

Classification and verification of direct shear and strength-test apparatus for multi-scale rock mass discontinuity

Loading Measurement for Intermediate Strain Rate Material Test Based on Dynamic Oscillation

Testing Machine for Testing Durability of Material under High-Pressure Hydrogen Circumstance

Development of Structural Testing Equipment for Impact and Complex Loading

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

Verification of A Multiple-Machine Program for Material Testing from Quasi-Static to High Strain-Rate

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Design and Verification of a Strain Gauge Based Load Sensor for Medium-Speed Dynamic Tests with a Hydraulic Test Machine

Development and application of novel hollow cylinder apparatus

Multifunctional In-Situ Testing Device for Investigating the Service Performance of Materials

An Automatic Three-Dimensional Loading Apparatus for Static Tests of Truss Joints

Development of a Large-scale Computer-controlledCompression-torsional Multi-axial Loading Apparatus

Development of constant strain increment ratio path tests

An alternative method for the measurement of mechanical properties at intermediate strain rates: a numerical study

Device and method for investigation of mechanical properties of the materials under high-strain rate tensile load

Apparatus for material tests using an internal loading system in high-pressure gas at room temperature

Investigation of Effect of Temperature and Strain Rate on Mechanical Properties of Underfill Material by Use of Microtensile Specimens