Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Development and application of novel hollow cylinder apparatus

Development of a Compacting Instrument for Reconstituted Samples in Hollow Cylinder Apparatus

Preparation of Hollow Cylindrical Samples of Intact Soft Clay

Preliminary Study of Dynamic Testing Performance of Hollow Cylinder Apparatus

The Analysis and Comparison on the Performance Index of Hollow Cylinder Apparatus in the World

Implementing Ultrasonic Guided Wave Mode Control in Hollow Cylinders

Possible Stress Path of HCA for Cyclic Principal Stress Rotation under Constant Confining Pressures

Design and Control of Multilevel Loadings Hydraulic System of Direct Shear Apparatus

Study and Countermeasure on Side Effects from Principal Stress Axis Rotation Experiment with Hollow Cylinder Apparatus

Development of Structural Testing Equipment for Impact and Complex Loading

Undrained Behaviour of Intact Soft Clay under Cyclic Paths That Match Vehicle Loading Conditions

Development of a Large-scale Computer-controlledCompression-torsional Multi-axial Loading Apparatus

Analysis on Ability of HCA to Imitate Cyclic Principal Stress Rotation under Constant Confining Pressure

Development and Application of 3D Soil-Structure Interface Test Apparatus

BEHAVIOR OF PORE WATER PRESSURE IN DYNAMIC TRIAXIAL TESTS OF SATURATED SOFT CLAY AND ITS EFFECT ON EFFECTIVE STRESS PATH

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Cyclic response of natural soft marine clay under principal stress rotation as induced by wave loads

Addressing the inherent stress non-uniformity in dynamic hollow cylinder testing

Intact soft clay responses to cyclic principal stress rotation in undrained Condition

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation