Abstract:Although Toyoura sand has been widely used as a standard material for physical model tests (particularly centrifuge model tests), its path-dependent stiffness degradation curves are rarely reported in the literature. This leads to difficulties in back-analyzing and understanding the physical tests involving significant changes in the direction of stress paths (such as unloading problems). In this study, path-dependent stiffness degradation curves of medium-dense Toyoura sand were determined by carrying out a series of stress-path triaxial tests, with local strain measurements. In the triaxial tests, four typical recent stress histories (changes of path direction = 0, 90, -90, and 180 degrees) were simulated. The measured small strain stiffnesses of Toyoura sand were then used to calibrate an advanced hypoplastic model that accounts for path-dependent soil stiffness at small strains. To justify the validity of the calibrated hypoplastic model and model parameters, a Type A numerical prediction and a centrifuge model test were carried out to simulate a typical unloading problem (i.e., excavation) in medium-dense Toyoura sand. Triaxial test results show that a 180 degrees reversal in the direction of the stress path increased the initial secant modulus of Toyoura sand by eight times. The path dependency of soil stiffness, however, vanished when the deviatoric strain exceeded 0.3%. The ground deformations (resulting from excavation) predicted by the numerical analysis show reasonable agreement with the measured data from the centrifuge test. This suggests the potential applicability of the calibrated soil model and its model parameters in predicting or back-analyzing other physical model tests in Toyoura sand.

Addressing the inherent stress non-uniformity in dynamic hollow cylinder testing

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Preliminary Study of Dynamic Testing Performance of Hollow Cylinder Apparatus

Development and application of novel hollow cylinder apparatus

Development of a Compacting Instrument for Reconstituted Samples in Hollow Cylinder Apparatus

Experimental study on stiffness change of saturated soft clay with different degrees of consolidation under cyclic loading

Undrained Behaviour of Intact Soft Clay under Cyclic Paths That Match Vehicle Loading Conditions

BEHAVIOR OF PORE WATER PRESSURE IN DYNAMIC TRIAXIAL TESTS OF SATURATED SOFT CLAY AND ITS EFFECT ON EFFECTIVE STRESS PATH

Effect of Drained Static Shear on Cyclic Deformation Behavior of K-0-consolidated Sand

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation

Deformation behaviors of sandy subgrade soil under traffic load-induced stress path

Undrained Dynamic Behaviors of Saturated Clays under Compressive Stress Paths Considering Cyclic Confining Pressure

Study on dynamic stress-strain relationship of soft clay considering degradation of stiffness under cyclic loading

Possible Stress Path of HCA for Cyclic Principal Stress Rotation under Constant Confining Pressures

Cyclic Behavior of Saturated Soft Clay under Stress Path with Bidirectional Shear Stresses

Anisotropic and Noncoaxial Behavior of K0-Consolidated Soft Clays under Stress Paths with Principal Stress Rotation

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control