Abstract:Three titanium alloys with 0.5, 6, and 9 wt.% iron were investigated, and the samples were pre-annealed in three different regions of the Ti-Fe phase diagram, namely β, α+β, and α+FeTi. After annealing, five samples of different phases and structural compositions were studied. They were then subjected to the high-pressure torsion (HPT). The microstructure of the samples before and after HPT treatment was studied using transmission and scanning electron microscopy. The microstructure of the samples obtained during heat treatment before HPT treatment had a fundamental effect on the microstructure after HPT. Grain boundary layers and chains of particles formed during the annealing process made it difficult to mix the material during HPT, which led to the formation of areas with non-uniform mixing of components. Thus, the grain boundary layers of the α-phase formed in the Ti-6wt % Fe alloy after annealing at 670 °C significantly decreased the mixing of the components during HPT. Despite the fact that the microstructure and phase composition of Ti-6wt % Fe alloys pre-annealed in three different regions of the Ti-Fe phase diagram had significant differences, after HPT treatment, the phase compositions of the studied samples were quite similar. Moreover, the measured micro- and nanohardness as well as the Young's modulus of Ti-6wt % Fe alloy had similar values. It was shown that the microhardness of the studied samples increased with the iron content. The values of nanohardness and Young's modulus correlated well with the fractions of β- and ω-phases in the studied alloys.

Properties of Commercial Pure Titanium under Self-Heating and High-Pressure Heating Treatment

The effect of heat treatment system on mechanical properties of titanium alloy BTi-6554

Thermal Stability of Ultrafine-Grained Pure Titanium Processed by High-Pressure Torsion

Effect of High Temperature-High Pressure Treatment on Microstructure and Mechanical Properties of Cu-Cr Alloy

Effects of heat treatment on hydriding/dehydriding characteristics of Ti18Cr24V55Zr3 alloy

Effects of High Pressure Heat Treatment on Microstructure and Mechanical Properties of Aluminum Bronze

Influence of Heat Treatment on the Microstructure and Hydrogen Storage Properties of Ti10V77Cr6Fe6Zr Alloy

Effect of hot plastic deformation and heat treatment on microstructure and properties Of TC11 titanium alloy

Improvement of Mechanical Properties of Titanium Alloy by High-Density Pulsed Electric Current

Effects of Pre-Treatments on Bioactivity of High-Purity Titanium

Microstructural Characterization of Pure Titanium Treated by Laser Surface Treatment under Different Processing Parameters

Effects of Different Heat Treatments on Microstructure and Mechanical Properties of TC4-DT Titanium Alloy Bar

Effect of High-Pressure Torsion Temperatures on the Precipitation and Properties of Cu-Cr Alloy

Effects of 3 GPa High Pressure Treatment on the Β1→ Α + Β2phase Transition Dynamics of TC4 Titanium Alloy

The Determining Influence of the Phase Composition on the Mechanical Properties of Titanium-Iron Alloys after High-Pressure Torsion

Microstructural Evolution of Metastable Austenitic Steel During High-Pressure Torsion and Subsequent Heat Treatment

Microstructural Evolution and Mechanical Strengthening Mechanism of the High Pressure Heat Treatment (HPHT) on Al-Mg Alloy

Effect of composition, annealing temperature, and high pressure torsion on structure and hardness of Ti–V and Ti–V–Al alloys

Effect of Post-ECAP Annealing on the Microstructure and Mechanical Properties of Commercially Pure Titanium

Experimental Study on Pure Titanium During the Positive-Torsion and Positive-Negative-torsion

Effect of Heat Treatment on the Microstructure and Mechanical Properties of BT14 Titanium Alloy