Abstract:The hot band of CC AA 3003 aluminum alloy was cold-rolled to different reductions, and then annealed at 482 degrees C for 1 h under different pressures. The evolution of microstructure and texture was investigated. High pressure heat treatment can refine recrystallized grains and weaken pinning effect. The average grain size decreases from 205.17 mu m to 73.54 mu m with the increasing pressure from atmosphere pressure to 6 GPa. In the meanwhile, the aspect ratio increases from 0.18 to 0.72. Compared with atmosphere pressure, the fine precipitates (50 -150 nm) disappear after pressurization, the number density of large precipitates increases and the average size of large precipitates decreases. The recrystallization textures are characterized by the weak P and R-cube(ND) components and a relatively strong M component under atmosphere pressure. The intensities of the P and M components increase with the increasing rolling reduction, while the R-cube ND component changes slightly. With the increase of pressure, the P and R-cube ND components strengthen, while the M component weakens significantly, nearly disappears. The hardness decreases slightly with the increasing rolling reduction in the sheets annealed under atmosphere pressure and increases slightly with the increasing rolling reduction after pressurization. In addition to that, the hardness increases slightly with the increasing pressure in the sheets with the same rolling reduction. (C) 2022 The Author(s). Published by Elsevier B.V.

Effects of High Pressure Heat Treatment on Microstructure and Mechanical Properties of Aluminum Bronze

Effect of High Temperature-High Pressure Treatment on Microstructure and Mechanical Properties of Cu-Cr Alloy

Pressure Effects on Solid State Phase Transformation of Aluminium Bronze in Cooling Process

Effect of Heat-Treatment Temperature on Microstructure and Mechanical Properties of High Strength Aluminum Bronze

Effects of High Pressure Treatment on Microstructure and Electrical Conductivity of CuCrAI Alloy

Effects of 4 Gpa Pressure Heat Treatment on Microstructure and Micro-Mechanical Properties of Lc4 Aluminum Alloy

Effect of Heat Treatment on Microstructure and Properties of Hot-Extruded Nickel-Aluminum Bronze

Effect of High-Pressure Aging Treatment on Microstructure and Properties of Cu-51.15W-0.24Cr Alloy

Effects of Heat Treatment on Microstructure and Wear Behavior of Modified Aluminum Bronze Coatings Fabricated by Laser Cladding

Microstructure and Mechanical Properties of a 6061 Aluminum Alloy Part Prepared by Casting-Forging Integrated Forming Technology

Effect of Forging Pressure on Microstructure and Mechanical Properties of 6061 Alloy Prepared by Casting-Forging Compound Forming

Effect of high pressure treatment on Ni50Al30Fe20 intermetallic alloy

Influence Of Heat Treatment On Tribological Behaviors Of Novel Wrought Aluminum Bronze

Properties of Commercial Pure Titanium under Self-Heating and High-Pressure Heating Treatment

Influence of heat treatment on microstructure and nanohardness of TiAl alloy solidified under high pressure

Effects of Solidification Pressure and Heat Treatment on the Microstructure and Micro-Hardness of AlSi9CuMg Alloy.

Effect of Holding Pressure on Microstructure and Mechanical Properties of A356 Aluminum Alloy

Study on microstructure, mechanical properties, and texture of the CC AA 3105 aluminum alloy processed by high-pressure heat treatment

Microstructural Evolution and Mechanical Strengthening Mechanism of the High Pressure Heat Treatment (HPHT) on Al-Mg Alloy

Effect of Heat Treatment on Microstructures and Mechanical Properties of A356 Alloy by Low Pressure Casting

Effect of high pressure heat treatment on the recrystallization and recrystallization texture of CC AA 3003 aluminum alloy