Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

All-fiber 177.6 W Supercontinuum Source

High Power All-Fiber Supercontinuum System Based on Graded-Index Multimode Fibers

Supercontinuum generation based on nanofiber

714 W all-fiber supercontinuum generation from an ytterbium-doped fiber amplifier

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

40 W of supercontinuum generated by a self-pulsed pump-sharing oscillator-amplifier

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

High Power, Continuous-wave Supercontinuum Generation in Highly Nonlinear Fibers Pumped with High Order, Cascaded Raman Fiber Amplifiers

All Fiber Structured Supercontinuum Source Based on Graded-Index Multimode Fiber

Power-efficient Coherent Supercontinuum Generation by Two-Color Pulses Pumping in a Highly Nonlinear Fiber.

Supercontinuum generation with high power efficiency in a highly nonlinear fiber pumped by two-color pulses

Near-infrared supercontinuum generation in an all-normal dispersion MOPA configuration above one hundred watts

74 Nm, 2.5 GHz Supercontinuum Generation in a Dispersion-Shifted Fiber

On-Chip Supercontinuum Generation Pumped by Short Wavelength Fiber Lasers

High-power all-fiber superfluorescent source with fused angle-polished side-pumping configuration.

Supercontinuum generation and control from large-mode-area photonic crystal fiber

High power high repetition rate supercontinuum generation in graded-index multimode fibers

All Fiberized Supercontinuum Laser Source Based on “figure of Eight” Cavity Modelocked Yb Fiber Laser

Kilowatt-level supercontinuum generation employing a homemade taper-shaped ytterbium-doped fiber amplifier

Numerical investigation of a wideband supercontinuum source based on a large-mode-area photonic crystal fiber pumped at 1.3 μm

Supercontinuum Generation in Graded Index Multimode Fiber Pumped by Superluminescent Pulse Amplification