Abstract:The stereo-vision methods have been developed and used for measuring the wing deformation while the aircraft is in flight. However, it is difficult to achieve accurate measurement in flight test since inevitable camera movements often occur due to elasticity in the camera support and the surrounding structure, especially during heavy turbulence and large maneuver flight. Any slight camera movements within a stereo-vision system can directly influence the calibrated extrinsic parameters, then decrease 3D reconstruction accuracy, and even cause the measurement to fail. This study proposes a method to correct the effect of the camera movements to enable accurate wing deformation measurement using a stereo-vision system. A reference coordinate system is established based on the control points to unify the changing camera coordinate system. A dynamic extrinsic parameters calibration algorithm is developed to estimate the instantaneous position and orientation of the stereo cameras. To verify the presented method, an experiment in which the stereo cameras occurring relative movement was performed. The results show that the proposed method has effectively corrected the effects of camera movements. Furthermore, the proposed method was applied to the practical wing deformation measurement of a UAV in fieldwork. The maximum error of length and displacement is less than 0.8 mm when the stereo cameras remained unchanged. The actual accuracy of the overall measurement system is about 0.01% of the observed area (e.g. 0.8 mm in 6 m scale) under the conditions of flat viewing angle and outdoor scenes. While camera movements occur during the test, the corrected RMS error of displacement is reduced to about 1.5 mm and has decreased by 50% compared with that before correction. The enhanced precision and robustness of wing deformation measurement are well realized by the proposed method of correcting camera movements.

Principle of Real-Time Measurement of Deformation on the Wing by Using Two-Laser Range

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Interference detection method of wing-fuselage joints based on measured data

A novel videogrammetry-based full-field dynamic deformation monitoring method for variable-sweep wings

Research on Measurement and Deformation of Flexible Wing Flapping Parameters

Wing deformation measurement using the stereo-vision methods in the presence of camera movements

High‐resolution Method for Measuring the Torsional Deformation of a Dragonfly Wing by Combining a Displacement Probe with an Acousto‐optic Deflector

Dynamic Deformation Measurement of Bionic Flapping-Wing Robot Based on Fiber Bragg Grating Array

Measurement on Camber Deformation of Wings of Free-flying Dragonflies and Beating-flying Dragonflies

Monocular In-flight Measurement of Airfoil Deflections

Effect of sunscreens, irradiance and resting periods on the germination ofMetarhizium flavoviride conidia

Measuring the Camber Deformation of A Dragonfly Wing Using Projected Comb Fringe

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

A New Method for Measuring the Thickness and Shape of A Thin Film Simultaneously by Combining Interferometry and Laser Triangulation

Reconstructing full-field flapping wing dynamics from sparse measurements

Robust Vision-Based Method for Wing Deflection Angle Measurement with Defocus Images

Test simulation study on flutter characteristics of airfoil

Monitoring of a Highly Flexible Aircraft Model Wing Using Time-Expanded Phase-Sensitive OTDR

Optical Measurement of the Deformation, Motion, and Generated Force of the Wings of a Moth, Mythimna Separata (Walker).

Experimental Study on Flexible Deformation of a Flapping Wing with a Rectangular Planform

Measuring the Body Position, Attitude and Wing Deformation of a Free-Flight Dragonfly by Combining a Comb Fringe Pattern with Sign Points on the Wing