Abstract:In order to clarify the effect of particle coagulation on the heat transfer properties, the governing equations of nanofluid together with the equation for nanoparticles in the SiO2/water nanofluid flowing through a turbulent tube are solved numerically in the range of Reynolds number 3000 <= Re <= 16,000 and particle volume fraction 0.005 <= phi <= 0.04. Some results are validated by comparing with the experimental results. The effect of particle convection, diffusion, and coagulation on the pressure drop increment P, particle distribution, and heat transfer of nanofluid are analyzed. The main innovation is that it gives the effect of particle coagulation on the pressure drop, particle distribution, and heat transfer. The results showed that increment P increases with the increase in Re and phi. When inlet velocity is small, the increase in increment P caused by adding particles is relatively large, and increment P increases most obviously compared with the case of pure water when the inlet velocity is 0.589 m/s and phi is 0.004. Particle number concentration M-0 decreases along the flow direction, and M-0 near the wall is decreased to the original 2% and decreased by about 90% in the central area. M-0 increases with increasing Re but with decreasing phi, and basically presents a uniform distribution in the core area of the tube. The geometric mean diameter of particle GMD increases with increasing phi, but with decreasing Re. GMD is the minimum in the inlet area, and gradually increases along the flow direction. The geometric standard deviation of particle diameter GSD increases sharply at the inlet and decreases in the inlet area, remains almost unchanged in the whole tube, and finally decreases rapidly again at the outlet. The effects of Re and phi on the variation in GSD along the flow direction are insignificant. The values of convective heat transfer coefficient h and Nusselt number Nu are larger for nanofluids than that for pure water. h and Nu increase with the increase in Re and phi. Interestingly, the variation in phi from 0.005 to 0.04 has little effect on h and Nu.

Investigation of Viscosity of SiO2 Heat Transfer Oil Nanofluid

Viscosity Modification of Lubricating Oil Based on High-Concentration Silica Nanoparticle Colloidal System

Stability and thermal conductivities of hybrid sphere/tube TiO2 nanofluid

Experimental Study on Factors Influencing Viscosity of Nanofluids

Investigation on Thermal Properties of Al2O3 Nanofluids

Particle Distribution and Heat Transfer of SiO<sub>2</sub>/Water Nanofluid in the Turbulent Tube Flow

An experimental study on characterization, stability and dynamic viscosity of CuO-TiO2/water hybrid nanofluid

Effect of particle size on SiO2 nanofluid viscosity determined by a two-step method

Effects of shear rate and temperature on viscosity of alumina polyalphaolefins nanofluids

Temperature Dependence of the Stability and Thermal Conductivity of an Oil-Based Nanofluid

An Experimental Study to Determine the Maximum Efficiency Index in Turbulent Flow of SiO2/water Nanofluids

Molecular Dynamics Simulation Of Temperature Impact On The Viscosity Of Transformer Oil-Based Nanofluids

Measurement and Correlation of the Viscosity of Water-Based Al2o3 and Tio2 Nanofluids in High Temperatures and Comparisons with Literature Reports

Viscosity of Low Concentration Nanofluids

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Fluid Flow and Heat Transfer Characteristics of Alumina Organic Nanofluid

Investigating the thermal properties of single-grade engine oil (SAE 50) with the simultaneous addition of MWCNT and CuO nanoparticles

RHEOLOGY OF METHANOL-BASED METAL OXIDE NANOFLUIDS: EFFECTS OF TEMPERATURE, PARTICLE TYPE, AND MASS FRACTION

Investigating the influence of temperature-dependent rheological properties on nanofluid behavior in heat transfer

Experimental Study On Convection Heat Transfer Of Nanocolloidal Dispersion In A Turbulent Flow

Experimental Study on Preparation and Physical Properties of Nanofluids