Abstract:This study experimentally investigates the performance of a compact gasketed plate heat exchanger (PHE) employing Al2O3 nanofluids prepared for several low concentrations of Al2O3 (0.01, 0.05, 0.10, 0.15 and 0.20 vol%) and base fluids of distilled water (DW) and its mixture with ethylene glycol (15% and 30% of EG) for several flow rates (0.03–0.093 l/s). The main thermophysical properties of those nanofluid samples were experimentally measured. The prepared nanofluids showed a Newtonian rheological behaviour and an increase in viscosity up to 7.5% for 0.2 vol%. The enhancements in the thermal conductivity were significant and the values were 7.3 %, 8.4% and 9.1% for Al2O3 nanofluids at 0.2 vol% compared to the base fluids DW, 15% EG and 30% EG, respectively. A newly developed experimental setup is used to run the nanofluids through the PHE under particular conditions for heating purposes (mainly high temperature), and their performance is evaluated in comparison with the conventional heat transfer fluids (the base fluids). Nusselt number, pressure drop, and energy efficiency factor were determined for the nanofluids and base fluids. The results indicated a heat transfer enhancement with the increase of the nanoparticles’ concentration reaching the maximum value of 27% at 0.2 vol% for DW based Al2O3 nanofluid and was accompanied by an increase in pressure drop of 8%. The heat transfer enhancement became lower with the increase of the EG percentage such as 19.1% at 0.2 vol% for 30% of EG based Al2O3 nanofluid. In addition, the energy efficiency factor increased by the addition of Al2O3 nanoparticles to the base fluids and with the increase of flow rates up to the value of 1.3 at the highest particles concentrations.This work provides an important step concerning the performance of particular design of Al2O3 nanofluids and operation conditions in compact PHEs towards the development of thermal management systems under the current industry’s trends for optimizing energy use and minimizing equipment size.

Fluid Flow and Heat Transfer Characteristics of Alumina Organic Nanofluid

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Experimental investigation on alumina nanofluids in vehicle heat exchanger

Studies on Evaluation of the Thermal Conductivity of Alumina Titania Hybrid Suspension Nanofluids for Enhanced Heat Transfer Applications

Numerical Study of Flow and Heat Transfer Characteristics for Al2O3 Nanofluid in a Double-Pipe Helical Coil Heat Exchanger

Analysis of the mechanism of enhanced heat transfer by nanofluids

Investigation on Thermal Properties of Al2O3 Nanofluids

Experimental study on cooling performance of nanofluid flow in a horizontal circular tube

Experimental investigation of heat transfer performance of Al2O3 nanofluids in a compact plate heat exchanger

Pressure Drop and Heat Transfer of Nanofluid in Turbulent Pipe Flow Considering Particle Coagulation and Breakage

Friction Factor and Heat Transfer of Nanofluid in the Turbulent Flow Through a 90° Bend

Effect of Al2O3/water nanofluid on performance of parallel flow heat exchangers

Nanofluid Heat Capacities

Flow and Heat Transfer Characteristics of Nanofluids Containing Rod-Like Particles in a Turbulent Pipe Flow

An Experimental Study on the Effect of Nanofluids on the Thermal Conductivity and Rheological Properties of a Coolant for Liquids

Effects of Nanoparticle Behaviors and Interfacial Characteristics on Subcooled Nucleate Pool Boiling over Microwire

Study on Enhanced Heat Transfer and Stability Characteristics of Al2O3–SiO2/Water Hybrid Nanofluids

Dispersion stability and thermal conductivity of propylene glycol-based nanofluids

Thermal study of single phase nanofluid model using radiative γAl2O3 nanomaterial under Hall current and momentum slip phenomena

Heat and mass transfer characteristics of Al2O3/H2O and (Al2O3+Ag)/H2O nanofluids adjacent to a solid sphere: A theoretical study

Turbulent heat transfer and flow analysis of hybrid Al2O3-CuO/water nanofluid: An experiment and CFD simulation study