Abstract:A new hybrid method based on the combination of the sol–gel process and the hydrothermal route was successfully used to prepare Pb 1 − x Mg x TiO 3 (PM x T) powders with x = 0.0, 0.05, 0.1, 0.2 and 0.3 at low temperature below 200 °C. By modifying the value of x, the impact of the Pb/Mg ratio on the structural, morphological and dielectric characteristics was examined. Analysis of the compounds obtained using X-ray diffraction (XRD) and Rietveld refinement method shows that all the compounds crystallize in a pure perovskite-type phase, demonstrating that magnesium doping within the quadratic structure of PbTiO 3 (P4mm) reduces the tetragonality (c/a) of the crystal lattice, and the proportion of the pseudo-cubic structure (Pm3m) increases progressively, reaching a maximum of 92.38% at a magnesium concentration of x = 0.3. Examination using a scanning electron microscope (SEM) shows that the average grain size decreases as a function of the Mg content, ranging from 4.371 μm for pure PbTiO 3 to 0.412 μm for PT-Mg with x = 0.3. The frequency-dependent dielectric properties were studied by complex impedance spectroscopy in the temperature range from RT to 550 °C where a structural phase transition and two anomalies A and B were observed as a function of temperature at different measurement frequencies for all ceramics, showing a decrease in maximum permittivity (ε rmax ) with magnesium content down to a low value around 30% magnesium (ε = 1248.86), with no significant influence on the ferroelectric-paraelectric transition temperature. The nature of the transition was studied using the Curie-Weiss law, which showed that diffusivity increased with Mg 2+ ion concentration. This may be explained by compositional fluctuations and structural disorder in the cation arrangement at crystallographic sites.

Preparation and Properties of Mg2+Doped Li4Ti5O12Ceramic Targets

Doping Effects of Ta on Conductivity and Microwave Dielectric Loss of MgTiO<sub>3</sub> Ceramics

Effect of Doped Mg2+ and Mn2+ on the Dielectric Properties of BaTiO3-metal Composite System

Doping Effects In (Ba0.85ca0.15)(Hf0.1ti0.9)O-3 Lead-Free Piezoelectric Ceramics Prepared Via Powder Injection Moulding Using Simple Binder

The effect of sintering agents on the sinterability and dielectric properties of Li2Mg3TiO6 ceramics

Bulk Mg-doped Spherical Lithium Cobalt Oxide Preparation and Characterization of Precursor

Structural evolution and microwave dielectric properties of MgO–LiF co-doped Li 2 TiO 3 ceramics for LTCC applications

Microwave Dielectric Properties of Low-Fired Li2TiO3–MgO Ceramics for LTCC Applications

Impact of Mg doping on the structural, morphological and dielectric properties of PbTiO3 ceramics synthesized by consecutive combination of sol–gel and hydrothermal methods at low temperature

Effect of TiO2 Coating on Sintering Properties and Thermal Shock Properties of MgO Ceramic

Temperature stability adjustment of cobalt-doped Li2MgSiO4 ceramic: its' sintering, dielectric, and mechanical properties

Preparation and effects of Mg-doping on the electrochemical properties of spinel Li4Ti5O12 as anode material for lithium ion battery

Sintering and Microwave Dielectric Properties of La(Mg0.5Ti0.5)O3 Ceramics Doped with La2O3–B2O3–TiO2 Glass

Enhanced mechanical and sintering properties of MgO-TiO2 ceramic composite via digital light processing

Sintering behavior, structural evolution, and dielectric properties of Li2+MgTiO4F microwave dielectric ceramics

The experimental investigation on preparation of Li-doped ZnO ceramic targets and sputtering thin films

Enhanced Temperature Stability and Fatigue-Resistant Behavior in MgTiO3-doped 0.948(k0.5na0.5)nbo3–0.052lisbo3 Lead-Free Ceramics

TiO2-assisted Mg-Ti-O-based ceramics improve thermal conductivity and microwave dielectric properties by modifying the microstructure

Effect of Mg on the Dielectric and Electrical Properties of BaTiO 3 -Based Ceramics

Effect of excess lithium on the structure and microwave dielectric properties of LiMg0.5Ti0.5O2 ceramics