Impact of Mg doping on the structural, morphological and dielectric properties of PbTiO3 ceramics synthesized by consecutive combination of sol–gel and hydrothermal methods at low temperature

E. H. Lahrar,H. Essaoudi

DOI: https://doi.org/10.1007/s10854-024-12206-2

2024-02-27

Journal of Materials Science Materials in Electronics

Abstract:A new hybrid method based on the combination of the sol–gel process and the hydrothermal route was successfully used to prepare Pb 1 − x Mg x TiO 3 (PM x T) powders with x = 0.0, 0.05, 0.1, 0.2 and 0.3 at low temperature below 200 °C. By modifying the value of x, the impact of the Pb/Mg ratio on the structural, morphological and dielectric characteristics was examined. Analysis of the compounds obtained using X-ray diffraction (XRD) and Rietveld refinement method shows that all the compounds crystallize in a pure perovskite-type phase, demonstrating that magnesium doping within the quadratic structure of PbTiO 3 (P4mm) reduces the tetragonality (c/a) of the crystal lattice, and the proportion of the pseudo-cubic structure (Pm3m) increases progressively, reaching a maximum of 92.38% at a magnesium concentration of x = 0.3. Examination using a scanning electron microscope (SEM) shows that the average grain size decreases as a function of the Mg content, ranging from 4.371 μm for pure PbTiO 3 to 0.412 μm for PT-Mg with x = 0.3. The frequency-dependent dielectric properties were studied by complex impedance spectroscopy in the temperature range from RT to 550 °C where a structural phase transition and two anomalies A and B were observed as a function of temperature at different measurement frequencies for all ceramics, showing a decrease in maximum permittivity (ε rmax ) with magnesium content down to a low value around 30% magnesium (ε = 1248.86), with no significant influence on the ferroelectric-paraelectric transition temperature. The nature of the transition was studied using the Curie-Weiss law, which showed that diffusivity increased with Mg 2+ ion concentration. This may be explained by compositional fluctuations and structural disorder in the cation arrangement at crystallographic sites.

engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied