Abstract:The breeder blanket and divertor are crucial plasma facing components in a fusion reactor. The helium cooled blanket and divertor concepts have exhibited the best potential to come up to the highest safety requirements and therefore been chosen for the development object. As a result of high heat flux radiated from the plasma in the fusion reactor and high power density nuclear heat deposited by high-energy neutrons, the cooling of the first wall (FW) and the discharge of nuclear heat have become one of the major technical challenges. To demonstrate and verify the helium-cooled technology and tools of China test blanket module, and explore the feasibility and key technology of thermal hydraulics process of helium-cooled divertor, we have creatively adopted the "filling-evacuating" approach to design and fabricate the high-pressure helium-cooled loop (HPHCL), in which a mock-up of reduced-scale helium-cooled blanket module is designed and manufactured as a test section. Based on different experimental cases, the operating pressures of helium at mockup range from 3 to 10 MPa and the maximum mass flow rate can reach up to 0.21 kg/s. In this paper, the design scheme of the HPHCL is presented, and the key issues of engineering manufacture and the test cases are calculated and analyzed. The helium gas flow and the heat transfer are calculated according to the test working conditions of the referenced International Thermonuclear Experimental Reactor TBM's FW surface heat flux, using ANSYS fluid dynamics software FLUENT. The results will provide support for the follow-up fabrication of test system and implementation of the tests.

Design and construction of a small helium loop

Design and construction of a helium cooling experimental loop

Design and Analysis of “Filling-Evacuating” High-Pressure Helium-Cooled Loop

Research on Improving the System Sensitivity for Hot Helium Leak Test

Helium Experiment Loop of CH HCSB TBM

Hot Helium Leak Test of ITER Blanket Shield Block

ICONE23-1913 DESIGN AND STUDY OF ENGINEERING TEST FACILITY : HELIUM CIRCULATOR

A Water Loop Design for the CRAFT Project Towards the Testing of CFETR Water-Cooled Blanket and Divertor

Design and test requirements of main loop shut-off valves in the helium test loop

Helium I Heat Transfer in A Small Natural Circulation Loop with Self-Sustaining Recondensation

Design and Research of a Laboratory-Scale Helium Purification Test Facility Based on Membrane

Engineering Design , Analysis and Testing of Helium Circulator used in HTR-PM

Helium test loop and test section of hot gas duct

Design and Commissioning of a 700 W@3 K Sub-cooled Helium Test Facility

Numerical Simulation of 1.8 K–300 K Sub-Atmospheric Helium Heating Device

The Preliminary Design of the Helium Cooling System for the Dual-Functional Lithium Lead Test Blanket Module for ITER

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Design and Optimization of a Helix Finned Tube Heat Exchanger for 2 K Superfluid Helium Vertical Test Stand

Study on Flow Characteristics of Helium

Design Analysis of DRAGON-IV LiPb Loop

Experimental design on performance improvement of the helium purification system of HTR 10