Abstract:Post-drilling wireline acoustic single-well imaging technology can now detect geological structures tens of meters away from boreholes. Further development of this single-well imaging technology in the logging-while-drilling (LWD) environment will have significant values in real-time applications such as geosteering and reservoir navigation. Based on the wireline imaging application, we propose a new method for the LWD application. In wireline imaging, the four-component (4C) dipole acoustic data are azimuthally rotated to scan the reflectors around the borehole. In LWD, azimuthal scanning is achieved by drilling rotation such that the 4C dipole system in the wireline is replaced by a one-dipole-source and two-receiver LWD system, where the two receivers are mounted on opposite sides of the drill collar. For the LWD application, we first developed the theory for LWD dipole shear-wave reflection imaging and validated the theory using 3D finite-difference waveform modeling. Using the analytical solution, we analyzed the far-field radiation directivity of an acoustic LWD dipole source and the effect of drilling rotation on the shear-wave reflection imaging using the LWD acoustic system. The LWD analysis results show that, for fast formations, the SH-wave is the dominant component for imaging, whereas for slow formations, the P-wave becomes important and can be used for imaging. Our results also indicate that the reflection data acquired by the system are affected by the speed of drilling rotation. The take-off azimuth at the wave radiation may be different from the incident azimuth at the wave reception. Knowing the rotation speed, this azimuth difference can be corrected. A further advantage of using the oppositely mounted receivers is that the reflected wave arrives earlier (later) at the front (back)-side receiver; thus, the arrival time difference between the receivers can be used to eliminate the 180°-azimuth ambiguity of dipole acoustic imaging. For reflection imaging, using the proposed LWD system configuration, we tested its azimuth sensitivity and validated its 180°-ambiguity solution using synthetic LWD and field wireline dipole data. The results of this work, therefore, provide a theoretical foundation for the development of the LWD acoustic reflection imaging system.

A new formation dip correction method for electrical imaging logging

Study on Numeric Simulation of Complex Resistivity Logging

The Resistivity Imaging LWD Method Suitable for Oil-Based Drilling Fluid

Reservoir evaluation method for complex resistivity using the borehole–surface electromagnetic method: A case study of an igneous reservoir in the K exploration area, China

A Novel Lateral Resistivity Logging-While-drilling (LWD) Method in Oil-Based Drilling Fluid

Signal detection of lateral resistivity LWD based on C4D technique with oil-based drilling fluid

Geologic Application of Diplogging

Numerical simulation and dimension reduction analysis of electromagnetic logging while drilling of horizontal wells in complex structures

Interface Detection of Near-Borehole Stratified Formation under Different Permeabilities Based on Seismoelectric Logs: A Finite-Difference Modeling

Calculation Method of Formation Dip Angle Based on Deep Learning

A Novel Approach for Electromagnetic Logging While Drilling Data Processing

An Inversion Method for Calculating Formation and Borehole Parameters in X-ray Lithology Density Logging

A theoretical analysis of the logging-while-drilling dipole acoustic reflection measurement

Deep-detection of formation boundary using transient multicomponent electromagnetic logging measurements

Modeling and Inversions of Acoustic Reflection Logging Imaging Using the Combined Monopole–dipole Measurement Mode

Study on Relationship Between Dielectric Constant and Water Content of Rock-Soil Mixture by Time Domain Reflectometry.

Anisotropic Correction for Resistivity Logging of Horizontal Well in Thin Interlayer Reservoir

Logging-while-drilling formation dip interpretation based on long short-term memory

Detection performance of azimuthal electromagnetic logging while drilling tool in anisotropic media

Resistivity Imaging on Borehole Wall by Means of Array Measurement

Simulation and Application of a New Electromagnetic Resistivity Tool with Array Compensation Propagation While Drilling