Abstract:Sandwich pipe (SP), consisting of two comparatively thin-walled metal tubes and a thick polymer or cement based core, is believed to be a feasible conception to transport hydrocarbons in deep sea. In this paper, the buckle propagation experiments were carried out on small-scale SP test specimens composed of two aluminium tubes and the polypropylene (PP) core. In association with experimental efforts, dedicated finite element models of SP test specimens under external pressure were established to reproduce the local collapse and consequent buckle propagating scenarios using the software ABAQUS, and good agreements were observed between the experimental and numerical results. Then, influencing mechanisms of inter-layer adhesion behaviour on the stress state, cross-section deformation and buckle propagation pressure of SPs were systematically studied, and broad parameter correlation analyses were performed to explore geometric and material properties of two steel tubes and polymer core on the buckle propagation pressure of SPs. The results show that good interface bonding conditions can markedly enhance the buckle propagation pressure of SPs and improve the energy dissipation and the deformation capacity of the structures. The core layer thickness and the ratio of the wall thickness between inner and outer tubes have extremely noticeable effect on the buckle propagation pressure of SPs. Additionally, based upon extensive numerical results, an empirical design expression was developed to conservatively estimate the buckle propagation pressure of SP systems for the no inter-layer adhesion case.

Envisage and analysis of sea trial on deep-water pipeline's resistance to external pressure

Dynamic Analysis of Pipeline Lifting Operations for Different Current Velocities and Wave Heights

Design and Performance Analysis of a Pressure Chamber for Simulation of Deep Sea Conditions

A Deep-Sea Large-Volume High-Pressure Simulation System—design, Analysis and Experimental Verification

Fatigue Failure Analysis and Simulation Calculation of Submarine Suspended Pipelines

Buckle Propagation of Sandwich Pipes under External Pressure

Buckling Response of Offshore Pipelines under Combined Tension, Bending, and External Pressure

FEA-Based Failure Analysis of a UHP Chamber for Simulation of Deep Sea Conditions

Buckling Response of Offshore Pipelines under Combined Tension and Bending

On Collapse Failure Analysis Of Subsea Corroded Sandwich Pipelines Under External Pressure

Numerical Simulation on Dynamic Behaviour of Deepwater J-lay Systems

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Local buckling of deepwater oil-gas pipeline under high hydrostatic pressure

Parametric study on the mechanical behavior of submarine pipeline for deepwater S-lay operation

Buckle Propagation Analysis of Deep-Water Petroleum Transmission Pipelines with Axial Tension

Configuration Analysis of Deepwater S-Lay Pipeline

Global buckling of pipelines in the vertical plane with a soft seabed

Analysis on Ultimate Bearing Capacity of Deepwater Submarine Pipe

Configuration of Submarine Pipeline for Deepwater S-lay Technique

On Elastic-Plastic Collapse of Subsea Pipelines under External Hydrostatic Pressure and Denting Force

Buckle Propagation of Offshore Pipelines under External Pressure