Experimental Investigation for Removal of Fluoride and Chloride from Waste Water with Bio-polymeric Ferric Sulfate

Wen-chao YU,Ya-dan GUO,Jin-quan CHEN,Ping LIANG,Peng LI,Xue-gang WANG

DOI: https://doi.org/10.3969/j.issn.1671-1815.2017.34.026

2017-01-01

Abstract:The removal of fluoride and chloride from wastewater coagulation experiments with highly efficient bio-polymeric ferric sulfate were introduced .The experiment results show that the removal rates of F -and Cl -in-creased with increasing the dosage of bio-polymeric ferric sulfate .When the pH increases , the treatment efficiency of F-and Cl -rises at the beginning then declines .Whether pH is too low or too high that will destroy the floccules , then affect the flocculation .In addition , when the dosage of bio-polymeric ferric sulfate is 3.3％ ( volume frac-tion), pH is 5～6, the reaction time is 5 min, the removal rates of F -is above 98.41％, and the residual concen-tration of F-is below 2.39 mg· L-1 , which is lower than the emission standards of pollutants for lead and zinc in -dustry.When the dosage of bio-polymeric ferric sulfate is 15％(volume fraction), pH value is 1.6～3.6, the re-action time is 15 min, the removal rates of Cl -is above 56.26％, and the residual concentration of Cl -is below 437.42 mg· L-1 .The experiments with flocculation show that the flocculating efficiencies and secondary sedimenta-tion of the self-made bio-polymeric ferric sulfate is obviously superior to the commercial polymeric ferric sulfate . Fitting the dynamic equation by experimental data showed that the pseudo-second-order model could be used to sim-ulate the adsorption of fluoride and chloride on bio-polymeric ferric sulfate .