Quantitative Investigation on Flocculation and Destruction of Poly-silicic-ferric (PSF) Coagulant

Ying Fu,Shui-Li Yu,Yan-Zhen Yu,Li-Ping Qiu
DOI: https://doi.org/10.3321/j.issn:0250-3301.2008.01.016
2008-01-01
Abstract:An inorganic polymer, poly-silicic-ferric (PSF) coagulant was prepared using water glass, FeSO4 x 7H2O and NaClO3 by copolymerization. A comparison of coagulation performance, distribution of residual flocs in finished water and influence of turbulent shear force on the flocs between PSF and polyferric aluminum (PFA) was explored by jar tests and particle counter approach. The results indicate that PSF has superior removal of COD at higher dose to PFA. Flocculating speed should not be much higher or lower when using PSF as coagulant in treating surface water, and excellent coagulation efficiency can be obtained by the close cooperation of flocculation speed with flocculation time, that is, higher flocculation speed should be consistent with shorter flocculation time. The PFA flocs are much easier destructed than PSF flocs when increasing the turbulent shear force, and the destructed PSF flocs tend to be more easily re-coupled than PFA flocs. From the order magnitude, the flocculation coefficient KA of PSF is from 10(-2) to 10(-3), in comparison with the destruction coefficient KB from 10(-7) to 10(-8). For particles whose size is smaller than 2 microm, KA of PSF is 4 order magnitude more than that of PFA, and KB of PSF is almost the same to that of PFA; while for the other particles, KA of PSF is 2 order magnitude more than that of PFA, and KB of PSF is almost ten times smaller than that of PFA.
What problem does this paper attempt to address?