Abstract:Objective]To reduce the testing cost and enhance the research reliability and efficiency,this paper introduced a new rapid detection method for testing VOC released from three-layer parquet. The M-CTE thermal extractor was explored to analyze the effect of environmental factors about release characteristics of VOC on the stable phase and to find the correlation between the rapid detection and 1 m3 traditional climate box method. [Method]This paper established a single factor experiment matched to the appropriate environmental conditions and to analyze the release rule of VOC under different temperature,relative humidity,ratio of air exchange rate and loading factor by using rapid sampling device and GC-MS conjunctively. On the one hand,the main components and release characteristics of the VOC released from three-layer parquet were probed. On the other hand,the influence of various environmental factors on VOC under equilibrium condition was analyzed. According to the release rule,the best condition was determined by rapid detection method. Meanwhile,the 1m3 traditional climate box method was used to characterize the concentration released during the process of natural attenuation. The data measured from the two kind of method was compared and the correlation was established. [Result]Results showed that: as the main components of VOC emission released from three-layer parquet, aromatics and esters had obvious changing trend in concentration. Besides some parts of alkanes,alkenes,aldehydes and ketones,small amounts of ethers,alcohols and acids were also found. Furthermore,the TVOC equilibrium concentration increased with the raise of temperature and relative humidity,but the higher the temperature,the less impact of humidity on it. Ratio of air exchange rate and loading factor had remarkable effect on TVOC emissions under high temperature and high moisture condition,the smaller the ratio of air exchange rate and loading factor,the larger the TVOC concentration were found from three-layer parquet in the stage of stable emission.[Conclusion]By comparing the data of 1 m3 traditional climate box method,we found the trend of VOC release was basically consistent and they had the same compounds. With the time going,the release quantity of TVOC gradually fell to a stable trend. The main components of VOC,esters and aromatic hydrocarbons,were derived from the organic solvent on surface working. Thus,environment friendly coating was recommended. High temperature and high moisture had a significant impact on release quantity of VOC from three-layer parquet by rapid detection method due to the synergy effect of temperature and humidity. The release quantity of VOC was apparently affected by the ratio of air exchange rate and loading factor under high temperature and moisture. The release rate of VOC tested by rapid detection method was apparently fast and reliable. Therefore,the new method could be used for rapid detection of VOC released from wood-based panels to deal with specific problems in the manufacturing process and improve the quality of products.

Design of DL-SW Micro-Cabin for Rapid Detection and Analysis of VOCs from Wood-Based Panels

Comparison of the Rapid Testing Method for VOCs-Emissions from Wood-Based Panels with the Chamber Method

Effect of Environment on the Release of VOCs from Wood-based Panel which Detected by DL-SW Micro-cabin

Volatile Organic Compound Emission from Medium Density Fiberboard Tested in a Small Environmental Chamber

Investigation of VOC Released from Three-Layer Parquet by Using A New Rapid Detection Method

Developing A Rapid Test Method for Measuring Volatile Organic Compounds from Three-Layer Parquet with Microchamber

Volatile Organi c Comp ounds Emission from Medium Density Fiberboard by Rapid Testing Method

Influence of Environmental Factors on Volatile Organic Compound Emissions from Plywood Tested by a Rapid Detection Method

A Rapid and Accurate Method, Ventilated Chamber C-history Method, of Measuring the Emission Characteristic Parameters of Formaldehyde/vocs in Building Materials

Research on Very Volatile Organic Compounds and Odors from Veneered Medium Density Fiberboard Coated with Water-Based Lacquers

Correlation of Two Environmental Chambers for Measuring VOC Emission from Wood-Based Panels

Determination of Volatile Organic Compound Emission from Wood-based Panels

Determination of the Equivalent Emission Parameters of Wood-Based Furniture by Applying C-history Method

Study on Determination Method of the Volatile Organic Compounds Emissions from Particleboards for Indoor Finishing

Dynamic—static Chamber Method for Simultaneous Measurement of the Diffusion and Partition Coefficients of VOCs in Barrier Layers of Building Materials

Comparative analysis of very volatile organic compounds and odors released from decorative medium density fiberboard using gas chromatography-mass spectrometry and olfactory detection

Identification and characterization of odorous volatile organic compounds emitted from wood-based panels

Correlation between the Desiccator Method and 1 m3 Climate Chamber Method for Measuring Formaldehyde Emissions from Veneered Particleboard

Emission characteristics of volatile organic compounds of building materials in small airtight chamber

Applying C-history method to measure the VOC emission parameters of building material and furniture: Tests and validation

Optimization of Headspace Solid-phase Microextraction of VOCs in Eucalyptus Particleboard