Abstract:Based on the extraction method presented by Smith et al. (2008), this paper proposes an improved method, the multi-emission/flush regression method, to simultaneously determine the initial emittable concentration and the partition coefficient. Compared to the extraction method, the proposed method has the following advantages: (1) it is unnecessary for the target volatile organic compounds (VOCs) to emit completely from the material, thus greatly reducing experimental time; (2) it provides a simpler way to obtain the partition coefficients of VOCs for tested materials and can avoid the measurement uncertainties at low VOC concentrations which often occur during the last few cycles of the extraction method; (3) it does not require grinding the building material into powders thus making this method more convenient to use. Comparisons were made between the initial emittable VOC concentrations determined by the original extraction method and the proposed method. Results show good agreements between these two methods. To further validate the proposed method, the type of static chamber developed by Wang et al. (2006) was used to conduct the experiment for a type of medium density board, and formaldehyde was selected as the target compound. Based on the initial emittable concentration and partition coefficient obtained using the proposed method, and the diffusion coefficient obtained by the mercury intruding porosimetry, the chamber formaldehyde concentration was predicted and compared with the experimental measurements. Results show that the predicted chamber VOC concentration using the measured parameters agree well with the experimental data.

A new method of measuring VOC emission characteristics of dry building materials

Measuring VOC Emission Characteristics of Building Materials in an Airtight Chamber

New method for determining VOC emission parameters for dry building materials

A new method, c-history based sink effect method, of determining key physical properties of VOC emission from dry building materials

A Rapid and Accurate Method, Ventilated Chamber C-history Method, of Measuring the Emission Characteristic Parameters of Formaldehyde/vocs in Building Materials

Applying C-history method to measure the VOC emission parameters of building material and furniture: Tests and validation

Characterisation of VOC and Formaldehyde Emission from Building Materials in a Static Environmental Chamber: Model Development and Application

A Novel Method for Measuring the Diffusion, Partition and Convective Mass Transfer Coefficients of Formaldehyde and VOC in Building Materials

Dynamic—static Chamber Method for Simultaneous Measurement of the Diffusion and Partition Coefficients of VOCs in Barrier Layers of Building Materials

Improved C-history Method for Rapidly and Accurately Measuring the Characteristic Parameters of Formaldehyde/vocs Emitted from Building Materials

A New Experimental Method for the Determination of Emittable Initial VOC Concentrations in Building Materials and Sorption Isotherms for IVOCs

Convenient, Rapid and Accurate Measurement of SVOC Emission Characteristics in Experimental Chambers

Analytical solution and dimensionless correlations for VOC emissions from dry building materials in static chamber

A variable volume loading method to determine the initial emittable concentration of VOC and formaldehyde in building materials

An improved extraction method to determine the initial emittable concentration and the partition coefficient of VOCs in dry building materials☆

Determination of concentrations of mobile volatile organic compounds, the partition coefficient and the diffusion coefficient in dry building materials

A general analytical model for formaldehyde and VOC emission/sorption in single-layer building materials and its application in determining the characteristic parameters

Evaluation methods of measurement accuracy of VOC emissions from building materials and emission references

C-History Method: Rapid Measurement Of The Initial Emittable Concentration, Diffusion And Partition Coefficients For Formaldehyde And Vocs In Building Materials

Comparative research between closed chamber C-history method and other methods for measuring characteristic parameters of building materials

Variable volume loading method: a convenient and rapid method for measuring the initial emittable concentration and partition coefficient of formaldehyde and other aldehydes in building materials.