Abstract:Circumferential Shear Horizontal (CSH) guided waves provide an effective method for detecting defects like axial cracks and corrosion in pipes. Periodic Permanent Magnet Electromagnetic Acoustic Transducers (PPM EMATs) are typically used to generate CSH guided waves. However, there is an offset problem to which little attention has been paid. The offset problem refers to the offset of the center (position of maximum energy) of the operating region caused by the variation in the peak frequency of the spatial spectra of PPM with 2 or fewer cycles. Furthermore, the excitability of guided waves is one of the factors that needs to be considered when selecting the excitation parameters of EMATs, but there are still some studies that have not sufficiently addressed this issue. In this paper, the offset problem and the excitability of CSH guided waves were investigated. Firstly, by obtaining the operating regions corresponding to PPM with different cycles, the cause and influences of the offset problem were studied. The results show that the offset in the peak frequency of the spatial spectrum of PPM is the fundamental reason causing the offset problem, and it not only leads to incorrect prediction of the excitation efficiency of guided waves but also affects the selection of the excitation parameters of EMATs. Secondly, finite element simulations and experiments were performed to assess the influence of the excitability on the excitation efficiency of the CSH0 and CSH1 modes in pipes. By analyzing the simulation and experimental results of 2-cycle PPM, as well as the simulation results for PPM with 1 to 5 cycles, the impact of the excitability on the CSH1 mode was confirmed from two perspectives. The final conclusion indicates that an accurate prediction of the amplitudes of CSH guided waves with different modes is only possible through a comprehensively consideration of the operating region of EMAT and the excitability of guided waves.

Longitudinal guided waves in pipes excited by non-axisymmetric multielement surface loading

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Implementing Ultrasonic Guided Wave Mode Control in Hollow Cylinders

Scattering of Torsional Flexural Guided Waves from Circular Holes and Crack-Like Defects in Hollow Cylinders

Excitation of Axisymmetric and Non-Axisymmetric Guided Waves in Elastic Hollow Cylinders by Magnetostrictive Transducers

Non-destructive Evaluation of Spiral-welded Pipes Using Flexural Guided Waves

RESEARCH ON FREQUENCY DISPERSION CHARACTERISTICS OF LONGITUDINAL GUIDED WAVE IN MULTI-LAYER TUBE

A New Procedure for Exploring the Dispersion Characteristics of Longitudinal Guided Waves in a Multi-layered Tube with a Weak Interface

Source Influence Analysis of Longitudinal Mode Guided Waves Propagating in Pipeline

Numerical and experimental investigations on quasi-static component generation of longitudinal wave propagation in isotropic pipes

Excitation of Dominant Flexural Guided Waves in Elastic Hollow Cylinders Using Time Delay Circular Array Transducers

DISPLACEMENT DISTRIBUTION OF LONGITUDINAL GUIDED WAVES IN COMPOSITE PIPES

Study on Pipe Circumferential SH Guided Wave Characteristics

Experimental Study of Static and Dynamic Loading Effects on Guided Wave-Based Intelligent Monitoring of Welded Rail Joints

A simplified analytical model for the investigation of contact acoustic nonlinearity in pipe structures

Guided wave-based bend detection in pipes using in-plane shear piezoelectric wafers

Excitation characteristics of circumferential SH guided waves in steel pipes generated by EMATs with few-cycle PPM

Mode Conversion Behavior of Guided Wave in A Pipe Inspection System Based on A Long Waveguide

Imaging of Nonaxisymmetric Area Discontinuities in Pipes Using Guided Wave Synthetic Focusing

Multi-belts Coil Longitudinal Guided Wave Magnetostrictive Transducer for Ferromagnetic Pipes Testing

Ultrasonic Guided Wave Testing Trials for Pipes