Dispersion Characteristics and Inspection Frequency Selection of Guided Waves in Hollow Cylinders
MA Shuyi,WU Zhanjun,LIU Kehai,WANG Yishou
DOI: https://doi.org/10.3901/jme.2014.20.008
2014-01-01
Journal of Mechanical Engineering
Abstract:The dispersion of guided waves is an important factor that affects the frequency selection in long range pipe inspection. By analyzing the dispersion characteristics of longitudinal guided waves in hollow cylinders, the selection of inspection frequencies for the commonly used modes L(0,2) and L(0,1) is studied. According to the dispersion phenomenon, the quantitative relationship between defect echo resolvable distance and excitation signal parameters is established, and then the problem of frequency optimization selection is analyzed. A distance parameter caused by dispersion of guided waves is defined, and basis on this, the limiting frequencies of L(0,2) and L(0,1) modes in non-dispersive region are calculated. It is shown that the optimized cycles of tone burst and frequencies can be selected by restricting and minimizing the defect echo resolvable distance. Along with the variation of pipe geometry, several important conclusions are drawn about the change rules of the L(0,2) and L(0,1) modes dispersion characteristics. For the L(0,2) mode, when the pipe inner-radius-thickness ratio is great than or equal to 4, the lower limiting frequencies diameter product is about 4.0 MHz·mm, and the upper limiting frequencies thickness product is about 1.06 MHz·mm. For the L(0,1) mode in small tubes the upper limiting frequencies diameter product is about 0.81MHz·mm. These simple function relationships provide reference for quickly determining the frequencies of non-dispersive region in pipe inspection.