Abstract:Structural Health Monitoring, Ahead of Print. Condition assessment of water transmission pipelines is of important necessity for prioritizing rehabilitation and preventing catastrophic pipe failure. Hydraulic transient analysis has been investigated for three decades for this purpose and applied to many field studies. However, the significant pipe vibrations caused by the transient generation process and the limited energy and bandwidth of conventional discrete transient pressure waves (e.g., step and pulse waves) limit the accuracy and resolution of the analysis. This paper reports a pilot field study of noninvasive and nondestructive pipe condition assessment using small amplitude and persistent hydroacoustic noise instead of conventional large and discrete hydraulic transient waves. By opening a discharge valve installed at an existing access point, such as an air valve, on the field pipe, hydroacoustic noise was generated at the valve due to the turbulence of the discharge. The hydroacoustic noise was measured by pressure transducers at this access point as well as some other access points along the field pipe. A signal deconvolution process was then applied to the measured hydraulic pressures to transfer them to a compositional impulse response function (IRF), which is composed of IRFs of different pipe sections. A mathematical model was derived to interpret the anomaly-induced spikes on the deconvolution trace. A time-shifting process on the compositional IRFs was proposed to find the locations with pipe condition changes from a specific direction of the pipe. The field study has shown that small-amplitude persistent hydroacoustic noise can replace conventional large hydraulic transient waves for pipe condition assessment.

Numerical and experimental investigations on quasi-static component generation of longitudinal wave propagation in isotropic pipes

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Scattering of Torsional Flexural Guided Waves from Circular Holes and Crack-Like Defects in Hollow Cylinders

Study on the effect of corrosion defects on VIV behavior of marine pipe using a new defective pipe element

Effect of Variable Cross-Section Rod on Laser-Induced Surface Acoustic Waves.

Theoretical and Experimental Studies of Longitudinal Guided Wave Generation in Hollow Cylinders by Multielement Transducers

Theoretical and Numerical Investigations of Acoustic Field Characteristics of Shear-Horizontal Feature Guided Waves in a Welded Joint

Numerical Investigation of Application of Unidirectional Generation to Improve Signal Interpretation of Circumferential Guided Waves in Pipes for Defect Detection

Assessment of thermal fatigue damage in square tubes using second harmonic generation of longitudinal waves

A simplified analytical model for the investigation of contact acoustic nonlinearity in pipe structures

Analysis and Experimental Study on the Measurement of Pipe Wall Thinning by Perturbation Method

Field study on proactive pipe condition assessment using hydroacoustic noise

Location Detection and Numerical Simulation of Guided Wave Defects in Steel Pipes

Experimental Investigation of the Surface Corrosion Damage in Plates Based on Nonlinear Lamb Wave Methods

Evaluation of Early-Stage Fatigue Damage in Metal Plates Using Quasi-Static Components of Low-Frequency Lamb Waves

Assessment of early fatigue in solid plates using quasi-static component by Lamb wave propagation under group velocity matching

On the scattering of elastic waves from a non-axisymmetric defect in a coated pipe

Fluid Pipe Nondestructive Testing Based on Ultrasonic Guided Waves

Nonlinear Rayleigh waves to detect initial damage leading to stress corrosion cracking in carbon steel

Quantitative assessment of corrosion-induced wall thinning in L-shaped bends using ultrasonic feature guided waves

Experimental and Numerical Studies of Nonlinear Ultrasonic Responses on Plastic Deformation in Weld Joints