Abstract:As a common type of highway bridges,a rigid frame bridge with double-limb piers being higher than 40 meters may enter a plastic stage under strong earthquakes. The structural characteristics of pier-beam consolidation make the longitudinal relative displacement between pier and beam not occur during earthquake,so dampers or vibrationisolation supports are seldom used on rigid frame bridges. Reinforced concrete( RC) tie-beams are usually arranged on double-limb high piers to reduce the calculation length and improve their stability under loads. Here,energy dissipation tie-beams are recommended to replace the traditional RC tie-beams,and the aseismic control effect of energy dissipation tie-beams on a rigid frame bridge with double-limb high piers under near and far field earthquakes was studied with the elasto-plastic dynamic time-history analysis. The study showed that under the far field earthquake,RC tie-beams can effectively enlarge the energy dissipation capacity of high piers,but shear forces at piers’ bottom are also enlarged,while the energy dissipation tie-beams can prevent pounding effect at beam ends and reduce shear forces at piers ’bottom;conventional beam-platform clearance actually limits the bridge’s longitudinal displacement response at the top of piers,and further limits plastic hinges’ development at piers’ bottom,so the pounding effect at beam ends and shear forces at piers’ bottom become the bridge’s main seismic response; the pounding effect at beam ends and shear forces at piers’ bottom of the rigid frame bridge with high piers under the near-fault seismic records are larger than those under the far field earthquake,while the decreasing amplitude ratio of energy dissipation tie-beams still is higher.

Experimental study on energy dissipation stopper for bridge

A Method for Controlling Seismic Damage of RC Bridge Piers Subjected to Strong Aftershocks

Earthquake Response of Bridge Restrainers Considering Failure of Bearings

Development of an Energy Dissipation Restrainer for Bridges Using a Steel Shear Panel

Development of Steel Dampers for Bridges

Development of Steel Dampers for Bridges to Allow Large Displacement Through a Vertical Free Mechanism

Study on the damping efficiency of continuous beam bridge with constant cross-section applied by lead rubber bearings and fluid viscous dampers

Aseismic control of a rigid frame bridge with double-limb high piers based on energy dissipation tie-beams

Design Method of Energy-Dissipated Earthquake-Reduction along Transverse of Long-Span Cable-Stayed Bridges

Energy Dissipation Enhanced by Multiple Hinges in Bridge Piers with CFST Y-Shaped Fuses

Study on design method of energy-dissipating earthquake-reduction along transverse of self-anchored suspension bridge by using lead dampers

Development of Crawler Steel Damper for Bridges

Seismic Isolation Design for Long-span Prestressed Concrete Continuous Girder Bridge

Experimental and numerical investigation of a novel passive energy dissipation system with viscoelastic damper and angle-reaction controller

Yielding Steel Dampers as Restraining Devices to Control Seismic Sliding of Laminated Rubber Bearings for Highway Bridges: Analytical and Experimental Study

Study on Energy Dissipation of Viscous Damper for Long-Span Suspension Bridges

Design method of energy-dissipating earthquake-reduction along longitudinal direction of self-anchored suspension bridge

Electromagnetic Shunt Damper for Bridge Cable Vibration Mitigation: Full-Scale Experimental Study

Experimental study on a cable-stayed bridge isolated with the combination of elastoplastic cables and fluid viscous dampers in the transverse direction

Research on earthquake-reduction design method of continuous girder bridges in a high-intensity earthquake area

Shaking table experimental study and theoretical analysis of the longitudinal seismic-reduced behavior of continuous-beam bridges