Abstract:Concrete-filled steel tube (CFST) arch bridges have a high center of gravity and a substantial mass, resulting in a discernible seismic response. Consequently, long-span CFST arch bridges must retain exceptional seismic performance and appropriate seismic control design. In this study, the dynamic response and seismic performance of a unique swallow-type CFST arch bridge when subjected to longitudinal earthquake forces were analyzed using numerical simulation methods. The displacement and axial force response results and their laws of the key bridge components were obtained. Taking into account seismic checking calculations, two damping measures were proposed for the CFST arch bridge, as the relative displacement of the girder end exceeded the allowable value specified. The appropriate design parameters for viscous dampers and lead shear dampers were examined. Additionally, the seismic performance of these dampers was verified through a shaking table test using a 1:16 scale model. The findings indicated that when subjected to Wenchuan Wolong wave action, the relative displacement between the steel box girder and the concrete girder of the bridge was significantly larger, leading to girder end pounding. The limit values were surpassed by 32.5% and 50%, when subjected to the uniform and traveling wave excitations, respectively, thus indicating that the expansion joint was the most vulnerable component. Following the selection of optimal parameters for the dampers, the dampers exhibited the capability to mitigate seismic and pounding impacts. Long-span CFST arch bridges with dampers were found to effectively reduce the seismic response of the skewback strain and vault, as well as the relative displacement of the girder ends. Furthermore, the average maximum damping rates achieved by the viscous damper and the lead shear damper reached 44.9% and 44.6%, respectively.

Shaking table experimental study and theoretical analysis of the longitudinal seismic-reduced behavior of continuous-beam bridges

Shaking Table Model Test of Long-span Continuous Girder Bridge with Longitudinal Seismic Energy Dissipating

Seismic Damage of Long Span Steel Tower Suspension Bridge Considering Strong Aftershocks

Shake Table Test on a Long-Span Cable-Stayed Bridge with Viscous Dampers Considering Wave Passage Effects

Study on the damping efficiency of continuous beam bridge with constant cross-section applied by lead rubber bearings and fluid viscous dampers

Shaking table test of isolated continuous girder bridge model under different earthquake intensity excitation

Stochastic Seismic Response Analysis of Long-span Continuous Rigid Frame Bridge

Study and Development on Shake Table Tests of Scaled Models of Bridge Engineering

Shaking table test study on the seismic control of concrete-filled steel tube arch bridges based on dampers

Experimental Study of Seismic Performance of Seismically Mitigated and Isolated Bridges Under Strong Earthquake

Seismic Analysis of Long Span Continuous Rigid-Frame Bridge with Thin-Walled High Piers

Shaking Table Test on Seismic Performance of Continuous Rigid Frame Bridge with Cast-in-place and Fabricated Super High Piers

Experimental study on longitudinal seismic damage progress and failure mode of a three-tower extradosed bridge

Design Method of Viscous Dampers in Shaking Table Model Test

Research on earthquake-reduction design method of continuous girder bridges in a high-intensity earthquake area

Seismic response of a Reduced-scale continuous girder bridge with rocking Columns: Experiment and analysis

SEISMIC VULNERABILITY ANALYSIS AND A SHAKING TABLE TEST OF A NEAR-FAULT CONTINUOUS VIADUCT

Experimental Study on Transverse Seismic Behavior of Long-Span Cable-Stayed Bridge with Two Inverted Y-Shaped Reinforced Concrete Towers

Shaking table tests and numerical studies on the seismic behaviors of FPB in railway continuous beam bridges

Research on Longitudinal Collapse Mode and Control of the Continuous Bridge under Strong Seismic Excitations