Abstract:Powder compaction and sintering are critical stages of powder metallurgy in manufacturing high performance particle reinforced metal matrix composites. In this paper, particulate scale numerical investigations on the warm compaction and solid-state sintering of TiC/316L composite powders with different particle size ratios (PSRs, R316L/RTiC) and TiC contents were performed using multi-particle finite element method (MPFEM) in two dimensions. The effects of PSR and TiC content, compaction pressure and temperature, and sintering temperature on the compaction and sintering processes were comprehensively analyzed. On this basis, a variety of macro- and microscopic analyses were conducted to further identify the densification dynamics and mechanisms. The results indicate that green compacts with higher relative density and more uniform stress distribution can be readily achieved by warm compaction. The large-scale plastic deformation of 316L particles caused by the cooperative actions of temperature and pressure is the main densification mechanism in warm compaction. During solid-state sintering, the improvement of relative density is mainly achieved by the vanishing or shrinkage of residual pores along with the growth of sintering necks, accompanied by the deformation of 316L particles. Large displacements of particles mainly occur in contacting areas of adjacent particles. Moreover, the equivalent stress in 316L particles is smaller than that in TiC particles. With the increase of PSR and TiC content, lower relative density of green compacts and sintered parts were obtained and more irregular morphologies of 316L particles can be observed.

High velocity compaction behavior and sintered properties of Ti-29Nb-13Ta- 4.6Zr alloy

Preparation and properties of Ti-Zr-Ta alloy assisted by hydrogenation

Mechanical and corrosion properties of Ti–29Nb–13Ta-4.6Zr alloy prepared by cryomilling and spark plasma sintering

Effects of Compaction Method and Sintering Process on Microstructure and Properties of Ti6Al4V Alloy Prepared by Sintering of Hydrogenerated Powder

Microstructure and Mechanical Properties of Ti6al4v Powder Compacts Prepared by Magnetic Pulse Compaction

Compaction Behavior and Densification Mechanism of the TA15 Titanium Alloy in Electromagnetic Compaction Processing

Microstructure and mechanical properties of the TiZrNbMoTa refractory high-entropy alloy produced by mechanical alloying and spark plasma sintering

Microstructure and mechanical properties of Ta–Ti alloy by plasma-activated sintering

Effect of Ti Additives on the Sintering Behavior and Mechanical Properties of ZrC-W Composites

Numerical study on the warm compaction and solid-state sintering of TiC/316L composite powders from particulate scale

Research on titanium alloy powder compact prepared by magnetic pulse compaction and heating

Compacting and Sintering Behavior of Nano ZrO 2 Powders

Microstructure and mechanical properties of Zn based composites reinforced by Ti3AlC2

Effects of Initial Density of Green Compact on Hot-Press Sintering and Superplastic Forming of Nano 3Y-TZP

Densification and Mechanical Properties of Tic by Sps-Effects of Holding Time, Sintering Temperature and Pressure Condition

Microstructure and Mechanical Properties of the Ti62Nb12Mo12Ta12W2 Refractory High Entropy Alloy Prepared through Spark Plasma Sintering

Investigation on the Microstructure and Mechanical Properties of the Ti-Ta Alloy with Unmelted Ta Particles by Laser Powder Bed Fusion

Influence of Oxygen and Zirconium Contents on The Mechanical Properties of Ti-23Nb-0.7Ta-Zr-O Alloys

Microstructure Evolution and Mechanical Properties of Ti-25Ta Alloy Fabricated by Selective Laser Melting and Hot Isostatic Pressing

Preparation of Bulk TiZrNbMoV and NbTiAlTaV High-Entropy Alloys by Powder Sintering

Investigation of the microstructure and physical properties of TaSi 2 sintered at high temperature and high pressure