Abstract:Numerical simulation and experimental methods were conducted to study the non-uniform thickness during hydroforming of a rectangular cross-sectional component by using a bent tube, which is thickened inside and thinned outside. A method of changing the contact sequence of the tube to the die surface is proposed to improve thickness distribution of hydroformed part. There are four contact sequences, Side-and-Side (SS), Side-and-Fillet (SF), Fillet-and-Side (FS) and Fillet-and-Fillet (FF), that are proposed through the preform shape for a rectangular section. The effect of contact sequence on thickness distribution was studied. The results show that SF or FF contact sequence makes the fillet corner contact with the die surface first and suppresses the further thinning in hydroforming. On the contrary, SF or SS contact sequence makes the straight side of the bend inside contact with the die surface first and benefits the full deformation of the thickening region in hydroforming. Among them, the SF contact sequence is the best for the uniformity of thickness, and SF and FF contact sequences are useful to ensure the minimum thickness of the section and help to avoid cracking defects. On the basis of it, two contact sequences, SS and FF, were applied to an instrument panel bar, respectively. There is a cracking defect in the circular section for the SS sequence, while there is no defect in the straight and circular sections for the FF sequence. And the sound part is successfully developed and applied to the assembly of the instrument panel bar of Chrysler 300C car in mass production.

Effects of loading paths on thickness distribution of a hydroforming component

Effect of Loading Paths on Hydroforming Tubular Square Components

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Thickness Improvement in Hydroforming of a Variable Diameter Tubular Component by Using Wrinkles and Preforms

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

Investigation of Loading Paths on the Forming Quality of X-shaped Tubes

Effect of Wrinkles on Formability in Hydroforming A Double-Diameter Aluminum Alloy Tubular Part

Experimental and Numerical Investigation on Axial Hydro-Forging Sequence of 6063 Aluminum Alloy Tube

Effect of the Load Path on Formability of T-Shaped Tube Hydroforming

Formability Influenced by Process Loading Path of Double Sheet Hydroforming

Hydroforming of Automotive Structural Components with Rectangular-Sections

Effect of Strain State on the Surface Roughening for Hydroforming of Aluminum Alloy Tube Based on Cross-Scale Numerical Modeling

Influence of loading paths on hydroforming process of stainless steel spherical part

The Study of Loading Path Optimization for Tube Hydroforming Process

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

An Approach to Improve Thickness Uniformity Within Tailor-Welded Tube Hydroforming

The Effects of Material Property Parameters on the Thickness Distribution of Hydroformed Parts

Thickness Improvement in Non-Homogeneous Tube Hydroforming of a Rectangular Component by Contact Sequence

Study on the Factors Affecting the Corner Filling Process in Hydroforming

Analysis and Finite Element Simulation of the Tube Bulge Hydroforming Process