Synthesis of Copolymer with Reversible Response to CO2/N2 Switching and Its Performance Evaluation
Liang KANG,Xian-wu JING,Hong-sheng LU,Zhi-yu HUANG
DOI: https://doi.org/10.13550/j.jxhg.2017.08.001
2017-01-01
Abstract:A polymer 〔P(DMAPMA-AM)〕 with response to CO2/N2 switching was synthesized via free radical polymerization of dimethylamino propyl methacrylamide (DMAPMA) and acrylamide (AM) using ammonium persulfate and sodium hydrogen sulfite as initiator.By single factor experiments,the optimum synthetic conditions were obtained as follows: the mole ratio of AM to DMAPMA was 4∶1,mass fraction of monomer was 25%,mole ratio of (NH4)2S2O8 to NaHSO3 was 2∶3,dosage of initiator was 0.2% (based on total mass of monomers),reaction temperature was 40 ℃,reaction time was 4 h.The resulting product was characterized by FTIR and 1HNMR.The conductivity,Zeta potential and mean particle size of polymer aqueous solution (mass fraction 0.2%) were measured before and after CO2 and N2 bubbling.Furthermore,the emulsifiability of P(DMAPMA-AM) was investigated.It was found that when the polymer solution was treated with CO2,the conductivity of the solution increased from 12.6 to 40.7 μs/cm,however,that reduced to 14.2 μs/cm after following treatment with N2.When the solution was successively treated with CO2 and N2,the Zeta potential increased from 1.25 to 10.11 mV and then dropped to 1.96 mV,and the average particle size initially decreased from 708.6 to 137.1 nm and then increased to 589.8 nm.These indicated that the synthetic polymer had reversible response to CO2 and N2 switching.Additionally,SEM results showed that treatment with CO2 and N2 could remarkably change the size of the polymer coils and amount of hydrophobic particles.CO2 and N2 could effectively make P(DMAPMA-AM) aqueous solution and diesel emulsified and demulsified.