Study of ZnS_xSe_(1-x) Thin Films for Ultraviolet LCLV in Transmission Mode

I.K.Sou
DOI: https://doi.org/10.3969/j.issn.1673-2812.2002.04.008
2002-01-01
Materials Science and Engineering
Abstract:Detailed description was given of the structure and operation of the novel ZnS xSe 1-x visible blind ultraviolet liquid crystal light valve(UV\|LCLV) in transmission mode.The opto\|electronic requirements of ZnS\-xSe 1-x photosensor for the device were derived and discussed from the UV LCLV electrical model and equivalent circuits.Suitable polycrystalline ZnS\-xSe 1-x film that provided a good matching with the requirements of LCLV were deposited on ITO coated quartz glass by molecular beam epitaxy technique (MBE).Room teperature photo\|responsivity measurements performed on these thin films show that the visible rejection power can reach as high as 3 orders in magnitude.The cutoff wavelength of the response is between 360nm~410nm and follows the energy\|gap dependence on the Se composition of the alloy thin films.The calculated absorption coefficient in UV spectrum is 3 orders higher than in visible region.The results of a.c.characterisation measurements further indicate that the film has a suitable ratio of dark/photo impedance and the dark impedance is between 10\+5~10\+6Ωcm\+2 at the low operation frequency(200Hz) of LCLV.
What problem does this paper attempt to address?