Abstract:Along with the rapid development of aerospace, automobile, die & mold industries, free-form surface products are widely used, and the measurement and reverse engineering of freeform surface products become research focus. Free-form surface products include many kinds of curve patches (flat, column surface, spherical surface, irregular surfaces, etc). The key in reverse engineering of free-form surface products is numerical measurement. Between the product surfaces and measuring platform is the skip edge, and C0&C1 continual edges are between the patches. Measuring by different areas compartmentalized according to the edges is a good method, which expedites the measurement and modeling. Even in whole measurement, the ship edge and C0&C1 continual edge are also important in surface modeling. In recent years, CCD camera or data point segmentation from massive data point clouds is often applied in edge detection research. But some negative factors still exist when using the CCD to integrate CNC machine such as difficult assembly, complicated system demarcation and high cost and so on. The disadvantages of using data point segmentation are low precision, lots of useless data points and measurement time, reduce the efficiency. In order to overcome the disadvantages, this article aims at laser non-contact measurement, an edge measuring method of free-form surface which is based of sampling is put forward. And it provides an idiographic way for the skip edge or C0&C1 continual edge which are widely uses in free surface parts. Because the edge detection method can make out measurement path according to the edge curve and optimize measurement points, the laser probe can adaptively measure the parts in a fast and accurate mode. Finally experiments show that the method is effective. And this method can be used to regulation part measurement too.

Rapid measurement of the verticality of end face on similar cylindrical workpiece

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Three-Dimensional Measurement System for Inner Surface of Long Tubular Parts Based on White Light Interference

A Novel Method to Simultaneously Measure the Straightness

1502 Precision Measurement of Vertical Straightness of a Roll Workpiece on an Ultra-Precision Lathe

An Improved Two-Point Real-Time Measuring Method for Radial Micro-Displacement Measurement on High-Speed Smart Boring Bar

Study on Edge Detection Based on Sampling in CNC Non-Contact Measuring System

Cassava and the roots of malnutrition.

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

A high-precision laser method for directly and quickly measuring 21 geometric motion errors of three linear axes of computer numerical control machine tools

Accurate Inner Profile Measurement of a High Aspect Ratio Aspheric Workpiece Using a Two-Probe Measuring System

On-machine Measurement of a Slow Slide Servo Diamond-Machined 3D Microstructure with a Curved Substrate

A line measurement method for geometric error measurement of the vertical machining center

Interior Profile Accuracy Assessment Method of Deep-Hole Parts Based on Servo Drive System

Development of an on-machine measurement system for ultra-precision machine tools using a chromatic confocal sensor

A Cost-Effective Method for Automatically Measuring Mechanical Parts Using Monocular Machine Vision

A Laser-Based Measuring System for Online Quality Control of Car Engine Block

A method combining laser and vision detection for on-line measurement of small modules gears