Abstract:The evaluation of the performance of organic Rankine cycle (ORC) depends on the measured data of the operating parameters. The influences of the measurement errors during the evaluation of the system’s performance, which are derived from the measuring instruments, are rarely studied in the literature. In order to explore the effects of measuring instruments’ accuracy on the evaluation of system performance, the error propagation model of a subcritical ORC system was established. The working fluids adapting to different operating temperature range, including R134a, R245fa and R123, were selected. Temperature, pressure and flow rate of fluid were adopted as the operating parameters that were measured. The net output power and the efficiency were used as the performance parameters that were evaluated. Sensitivity analyses of the measurement errors of single parameter and multiple parameters were conducted under five designed conditions. The results show that the key positions of the measurement errors affecting the performance evaluation were at the expander’s inlet, followed by the expander’s outlet, and the inlet and outlet of the fluid pump. To keep the errors of net output power and thermal efficiency within ± 10%, the measurement errors of the temperature at the inlet and outlet of the expander and fluid pump were less than ± 2%, ± 5%, ± 9% and ± 9% in all cases, respectively. To meet the same requirements, the measurement errors of the pressure at the inlet and outlet of the expander were less than ± 10% and ± 100% in all cases, respectively. The fluid adapting to higher operating parameters allowed higher measurement errors for both the temperature and the pressure. To keep the errors of net output power and thermal efficiency within ± 10%, the allowable measurement error of the expander’s inlet temperature increased from ± 0.8% for R134a to ± 2.0% for R123. The allowable measurement errors at the expander’s inlet decreased with the increase in the operating parameters for the same fluid. In most of the operating parameters, the allowable measurement errors of R245fa were larger than R134a and less than R123 under the same operating temperature range. The importance of the accuracy of temperature’s measurement outweighed those of pressure and flow rate. Finally, recommendations were made for the selection of accuracy of the measuring instruments.

Thermodynamical analysis of the effect of environmental conditions on measurement error of bell prover

Real Gas Effects on Charging and Discharging Processes of High Pressure Pneumatics

Analysis of Multi-Factor on Measurement Improvement of an Infrared Imager in Low-Temperature Environments

Compensation of Pressure Enthalpy Effects on Temperature Fields for Throttling of High-Pressure Real Gas

Design and Research of Signal Acquisition Circuit of Thermal Gas Flow-Meter

Characterization of a piston prover gas flow standard in variable ambient temperature conditions

Numerical Analysis of Transducer Installation Effect on Ultrasonic Gas Flow Meter

Investigation on Measurement Uncertainty in Air Conditioner Performance-testing Bench

Modelling Investigation on the Influence of Measurement Error on Performance Evaluation of Organic Rankine Cycle System

Calculation of Certain Important Parameters in the Simulation of Hydromechanical System

On fluctuation of the dynamic differential pressure signal of Venturi meter for wet gas metering

Analysis on Influence Factors of Differential Pressure Detection of Gas Leakage

The Reliability of Static Pressure Measurement With An Inertial Gas Gap Between Transducer and Viscous Slurries

Thermal Test of a Sealed Air Cooling Local Environment Control Apparatus for Precision Instruments

Experimental and Numerical Analysis of a Novel Flow Conditioner for Accuracy Improvement of Ultrasonic Gas Flowmeters

Analysis of Temperature Effect on Differential Pressure Method for Air Leak Detection

Experimental Investigation of Long-term Reliability for Temperature Monitoring in the Air Conditioning and Mechanical Ventilation Systems

A global thermodynamic measurement data reconciliation model considering boundary conditions and parameter correlations and its applications to natural gas compressors

Model simulation and error quantitative analysis of pipeline of ultrasonic gas flowmeter

Venturi Wet Gas Flow Modeling Based on Homogeneous and Separated Flow Theory

Error Analysis and Evaluation of Uncertainty on Dynamic Condition for Environmental Measurement and Control System of Hot Climate Wind Tunnel Laboratory