Abstract:Integrated systems are facing complex and changing environments with the wide application of atmospheric LiDAR in civil, aerospace, and military fields. Traditional analysis methods employ optical software to evaluate the optical performance of integrated systems, and cannot comprehensively consider the influence of optical and mechanical coupling on the optical performance of the integrated system, resulting in the unsatisfactory accuracy of the analysis results. Optical–mechanical integration technology provides a promising solution to this problem. A small-field-of-view LiDAR system with high repetition frequency, low energy, and single-photon detection technology was taken as an example in this study, and the Zernike polynomial fitting algorithm was programmed to enable transmission between optical and mechanical data. Optical–mechanical integration technology was employed to obtain the optical parameters of the integrated system under a gravity load in the process of designing the optical–mechanical structure of the integrated system. The experimental validation results revealed that the optical–mechanical integration analysis of the divergence angle of the transmission unit resulted in an error of 2.586%. The focal length of the telescope increased by 89 μm, its field of view was 244 μrad, and the error of the detector target surface spot was 4.196%. The continuous day/night detection results showed that the system could accurately detect the temporal and spatial variations in clouds and aerosols. The inverted optical depths were experimentally compared with those obtained using a solar photometer. The average optical depth was 0.314, as detected using LiDAR, and 0.329, as detected by the sun photometer, with an average detection error of 4.559%. Therefore, optical–mechanical integration analysis can effectively improve the stability of the structure of highly integrated and complex optical systems.

Study on the Control of Micro-Environmental Parameters in Long Distance Laser Interferometry

Research on multi-parameter measure and control technology based on wireless communication in combined environment testing

A High-Precision Laser Displacement Measurement System

Spatial-Temporal Distortions And Calibration Of Ultrashort Pulses In Complex Optical Systems

Anti Light Disturbance Analysis of the Measurement of High Precision micro Displacement

Study of Environmental Effect on Precise Position in Micromanufacture

Interferometer environmental error compensation based on refractive index's spatio-temporal coupling model

Research of Measurement and Measuring Error of Laser Interferometer in Step Imprint Lithography

Measurement and Control of Ambient Temperature for Metrological Atomic Force Microscope

Study of Environmental Effects on Precise Position in Micro-and Nano-manufacture

Analysis of the Effects on Ultra-Short Laser Pulse Beam Quality Caused by Errors in Optical Systems

A Design Method of Temperature Controller for High-Precision Laser

Laser Interferometer Technology and Instruments for Sub-Nanometer and Picometer Displacement Measurements

Optical–Mechanical Integration Analysis and Validation of LiDAR Integrated Systems with a Small Field of View and High Repetition Frequency

Study on Residual Cumulative Error in Fast Ultra-precision Measurement by Laser Interference

Study on the Effect of Micro-Force Perturbations and Temperature Fluctuation on Interferometer for the Taiji Program

Design of control system in electromagnetic interference environment of discharge excimer laser

Study of interferometric signal correction methods in ultra-precision displacement measurement

Study on Wide-range Device for High Precision Measurement

Noise Reduction of Air Turbulence Via Thequasi-Common-path Method.

Design and Realization of Atmospheric Parameters Profile Measuring System