Abstract:Knock is a crucial limiting factor for improving the thermal efficiency of spark-ignition gasoline engines. However, effective suppression of knock in an engine and accurate prediction of knock occurrence are still present research challenges. This study proposed an improved Livengood-Wu (L-W) knock integral model, which employs the local thermodynamic parameters, rather than the global ones, in the three-dimensional computational domain and a multi-region knock precursor method based on the L-W integral transport equation. The improved knock model was applied to study the knock suppression effect of targeted water injection, which directs water sprays to knock-prone areas in the end gas region. It was found that although the accuracy of the improved model in predicting the crank angle of knock onset under normal conditions without targeted water injection is similar to the empirical formula-based L-W models, the improved L-W model can catch the spatial details of knock and the influence of the local thermodynamic changes, being effective in the cases with great inhomogeneity of temperature and components. The numerical results indicated that the knock suppression effect of targeted water injection was significant. The cooling effect of the water-to-fuel ratio (w/f) from 5% to 10% is more significant than that from 10% to 20%. More water injected does not bring more significant cooling benefits to the target region, and w/f of 10% shows a better knock suppression effect. In the studied engine, targeted water injection with w/f of 10% is predicted to advance the ignition timing by 3°crank angles. In addition, the knock suppression effects of targeted water injection and conventional direct water injection without spray injection preference are also compared, which reveals a better effect of the targeted injection with less water. However, the knock tendency suppression is mainly effective in the watering-specific region (e.g. the exhaust side) and has little impact on the non-watering regions where knock may occur. This indicates that the knock suppression effect is limited by the knock tendency in the region without water injection, and further optimization of the design and control strategy of the targeted water injection is needed.

Vehicle engine knock analysis and control

Automatic Knock Control System

Design of Knock Control System for GDI Turbocharged Engine Based on Model

Numerical and Experimental Study on Knock Sources in Spark Ignition Engine with Electromagnetic Valve Train

Research on Knock Threshold Detection for Gasoline Engines

Knock Recognition of Knock Sensor Signal Based on Wavelet Transform and Variational Mode Decomposition Algorithm

Critical Knock Diagnosis for Gasoline Engines Based on Neural Network with Wavelet Transform and Fuzzy Clustering

Implementation and Parameter Analysis of the Knock Phenomenon of a Marine Dual-Fuel Engine Based on a Two-Zone Combustion Model

Experiment Study and Numerical Analysis of Suppressing Knock with Scavenging for Turbocharged GDI Engine

Simulation Research on the Effect of Cooled EGR, Supercharging and Compression Ratio on Downsized SI Engine Knock

A Predictive Model for Knock Onset in Spark-Ignition Engines with Cooled EGR

Beta-Distribution-Based Knock Probability Estimation, Control Scheme, and Experimental Validation for SI Engines

Study of On-Board Misfires Diagnosing Strategy of Electronically Controlled Engine

Numerical Investigation on Knock Combustion in a Diesel–Dimethyl Ether Dual-Fuel Engine

Knock Prediction Improvement with Application to the Analysis of Knock Mitigation with Targeted Water Injection in SI Engines

Numerical modeling of knocking combustion in spark ignition engines

An experimental study of knock analysis of HCNG fueled SI engine by different methods and prediction of knock intensity by particle swarm optimization-support vector machine

Analysis of Onset and Severity of Knock in Si Engine Based on In-Cylinder Pressure Oscillations

Effect of Rapid Combustion on Engine Performance and Knocking Characteristics under Different Spark Strategy Conditions

Experiment and Simulation Study on Performance and Knocking of Turbocharged DISI Engine

Progressive strategies to avoid and exploit knock limit for optimal performance and stoichiometric operation of a DI hydrogen engine with high CR at WOT conditions