Abstract:PHPs (pulsating heat pipes) are widely used as an efficient heat transfer element in equipment thermal management and waste heat recovery due to their flexibility. The purpose of this study was to design a heat transfer device that utilizes an asymmetric pulsating heat pipe structure by adjusting the lengths of selected pipes within the entire circulation pipeline. In the experiment, a constant temperature water bath was used as the heat source, with heat dissipated in the condensing section via natural convection. An infrared thermal imager was used to record the temperature of the condensing section, and the local wall temperature distribution was measured in different channels of the condensing section. Based on an in-depth analysis of the wavelet frequency, the following research conclusions are drawn: Firstly, as the heat source temperature increases, the start-up time of the pulsating heat pipe is shortened, the operating state changes from start–stop–start to stable and continuous oscillation, and the oscillation mode changes from high amplitude and low frequency to low amplitude and high frequency. These changes are especially pronounced when the heat source temperature is 80 °C, which is when the thermal resistance reaches its lowest value of 0.0074 K/W, and the equivalent thermal conductivity reaches its highest value of 666.29 W/(m·K). Secondly, the flow and oscillation of the working fluid can be effectively promoted by appropriately shortening the length of the condensing section of the pulsating heat pipes or the heat transfer distance between the evaporation and condensing sections. Third, under a low-temperature heat source, the oscillation frequency of each channel of a pulsating heat pipe is found to be low based on wavelet analysis. However, as the heat source temperature increases, the energy content of the temperature signal of the working fluid in each channel changes from a low- to a high-frequency value, gradually converging to the same characteristic frequency. At this point, the working fluid in the pipes no longer flows randomly in multiple directions but rather in a single direction. Finally, we determined that the maximum oscillation frequency of working fluid in a PHP is around 0.7 HZ when using the water bath heating method.

Experimental investigation of flow visualization and thermal performance of flat-plate single-loop pulsating heat pipes

Experimental investigation on heat transfer performance of closed-loop pulsating heat pipe with large inner diameter

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental and simulation study on flow heat transfer characteristics of flat pulsating heat pipe with wide and narrow interphase channels

Experimental Study on the Thermo-Hydrodynamic Characteristics of a Nitrogen Pulsating Heat Pipe

Thermo-hydrodynamic Analysis of a Nitrogen Flat-Plate Pulsating Heat Pipe Using CFD Modeling and Visualization Experiments

Visualization Study on the Enhancement of Heat Transfer for the Groove Flat-Plate Heat Pipe with Nanoflower Coated CuO Layer

THE EXPERIMENTAL INVESTIGATION OF PHASE CHANGE HEAT TRANSFER IN A FLAT PLATE HEAT PIPE

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe

Experimental Study on a Hydrogen Closed-Loop Pulsating Heat Pipe with Two Turns

Numerical Investigation on Pulsating Heat Pipes with Nitrogen or Hydrogen

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Visualization study of a flat confined loop heat pipe for electronic devices cooling

Investigation on Transient Behaviors of Flat Plate Heat Pipes

STUDY ON TWO-PHASE FLOW AND TEMPERATURE UNIFORMITY CHARACTERISTICS OF MICROCHANNEL HEAT PIPE

Experimental investigation of a flat plate heat pipe performance using IR thermal imaging camera

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Evaluation of the Heat Transfer Performance of a Device Utilizing an Asymmetric Pulsating Heat Pipe Structure Based on Global and Local Analysis

An Experimental Investigation on the Heat Transfer Characteristics of Pulsating Heat Pipe with Adaptive Structured Channels

FLOW AND HEAT TRANSFER CHARACTERISTICS IN NANOFLUID OSCILLATING HEAT PIPES